To Register the Magic Lighting Remote
You must pair the Magic Lighting Remote with the projector to use it.
Pair the Magic Lighting Remote prior to use as follows.
1
Put batteries into the Magic Lighting Remote and turn the Projector on.
2
Point the Magic Lighting Remote at your projector and press the
(OK) on the remote control.
•
If the projector fails to register the Magic Lighting Remote, try again after
turning the projector off and back on.
To Re-register the Magic Lighting Remote
1
Press the
and
the Magic Lighting Remote with your projector.
2
Wheel (OK) button towards the projector to re-register the
Press the
Magic Lighting Remote.
•
Pressing and holding the
Magic Lighting Remote at once.
buttons at the same time, for five seconds, to unpair
button will let you cancel and re-register
33
Wheel