Sebago Furniture Rockland Bed Assembly Instructions

Table of Contents

Download this manual

Rockland Bed Assembly Instructions, Rev 1. 121102

Dear Customer:

Thank you for purchasing a Rockland Bed from Sebago Furniture. The following

instructions will enable you to assemble your bed with a few simple tools.

PLEASE READ ALL OF THE INSTRUCTIONS BEFORE PROCEEDING TO

ASSEMBLE YOUR BED.

and align the pieces during the assembly process. Please do not hesitate to call

if you have questions or difficulty assembling your new bed.

Tools Required:

1. Medium size screwdriver

2. 9/16" Socket Wrench

3. 9/16" open end wrench (King Bed only)

207 - 591 – 4215

All manuals and user guides at all-guides.com

You should have another person available to help hold

Sebago Furniture

1. Locate the rails, header and

footer.

2. Place Header against wall where

the bed is to be located.

3. Position the Footer in front of the

header at its approximate final

location.

4. Place a Rail on either side

between the Footer and the

Header

www.sebagofurniture.com

Table of Contents

Do you have a question about the Rockland Bed and is the answer not in the manual?

Page 1 Rockland Bed Assembly Instructions, Rev 1. 121102 Dear Customer: Thank you for purchasing a Rockland Bed from Sebago Furniture. The following instructions will enable you to assemble your bed with a few simple tools. PLEASE READ ALL OF THE INSTRUCTIONS BEFORE PROCEEDING TO ASSEMBLE YOUR BED.
Page 2 All manuals and user guides at all-guides.com Rockland Bed Assembly Instructions, Rev 1. 121102 1. Locate four sets of bed bolts, washers and brass barrel nuts. 2. Start by attaching one rail to the Footer. 3. Insert the Brass Barrel Nut in the hole on the rail.
Page 3 All manuals and user guides at all-guides.com Rockland Bed Assembly Instructions, Rev 1. 121102 1. DO NOT CROSS THREAD the BARREL BOLT. 2. Align the first attached rail with the Header. 3. Tighten snuggly with the socket wrench. 4. Repeat the above process of securing the 1 rail to the Header.
Page 4 All manuals and user guides at all-guides.com Rockland Bed Assembly Instructions, Rev 1. 121102 PLATFORM ASSEMBLY Cont. 1. Your bed may have three or four platform pieces. Insert all as described above EXCEPT the LAST one. 2. The Last Piece requires two people and is marked with an “F”.
Page 5 All manuals and user guides at all-guides.com Rockland Bed Assembly Instructions, Rev 1. 121102 Attaching the King Foot 1. Using a slotted Screw Driver attach the foot using the four screws with the lock washer on the screw first followed by the plain washer.