Table of Contents
Advertisement
Genelec Oy 8351B
40
35
30
25
20
15
10
5
0
5
50
100
200
500
1k
Figure 11. The curve above shows the delay variation of the 8351B
as a function of frequency.
SYSTEM SPECIFICATIONS
Lower cut-off frequency, –6 dB
Upper cut-off frequency, –6 dB
Accuracy of frequency response, ± 1.5 dB
Maximum short term sine wave acoustic output on axis in half space, averaged from
100 Hz to 3 kHz at 1 m
Maximum long term RMS acoustic output in the same conditions with IEC weighted
noise (limited by driver protection circuit) at 1 m
Maximum peak acoustic output per pair in a listening room with music material at 1 m
Self generated noise level in free space at 1 m on axis (A-weighted)
Harmonic distortion at 90 dB SPL at 1 m on axis
Freq:
50...100 Hz
> 100 Hz
Drivers
Bass
Midrange
Treble
Weight
Dimensions
Height including IsoPod stand
Height without IsoPod
Width
Depth
AMPLIFIER SECTION
Bass amplifier short term output power
Midrange amplifier short term output power
Treble amplifier short term output power
(Long term output power is limited by driver protection circuitry)
Amplifier system THD at nominal output
Mains voltage
Power consumption
ISS active
Idle
Full output (short term)
10 Sept 2019
2k
5k
10k
20k
Frequency Hz
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment under
FCC rules.
< 32 Hz
> 43 kHz
38 Hz – 20 kHz
≥ 113 dB SPL
103 dB SPL
118 dB
≤ 5 dB
< 2 %
< 0.5 %
Dual 218 x 101 mm (8
/
5
8
130 mm (5 in) cone (coaxial)
25 mm (1 in) metal dome (coaxial)
14.3 kg (31 lb)
454 mm (17
/
in)
7
8
433 mm (17 in)
287 mm (11
/
in)
1
3
278 mm (11 in)
250 W
150 W
150 W
<0.05%
100-240 VAC 50/60 Hz
< 1 W
16 W
250 W
x 4 in) obround cones
7
Advertisement
Table of Contents
