Sony KD-43X8301C Service Manual page 149

Software update for Panel/T-CON replacement
Panel/T-CON replacement
After AC Plug-in, wait for 30sec then
turn on TV by power key on TV or
remote commander.
Check condition
Is it the Case 1 or 2?
<Case1>
Panel : No Picture
SMART CORE LED : Amber & Green blinking
Update to the latest software
version
*Remove all signal connection.
(antenna, external input, ether cable,
etc)
*Insert the USB memory.
SMART CORE LED will change to
white blinking. *After completes, TV
will reboot by itself and turns on.
*Disconnect the USB memory.
KD-43/49X8301C (FW-43/49X8370C), 8305C, 8307C, 8308C, 8309C
Check the software version
by Service mode.
Is it latest version?
<Case2>
Panel : Picture appear
SMART CORE LED : White Lit
Note1:
For a success of software writing,
it will take 20~30 min/time.
Note2:
Do not turn off TV while updating software.
If older software package version is used, software cannot be update.
TV will reboot and turn on again.
No
Yes
10sec then AC plug-in), turn on the TV
APPENDIX-1
Model Number setting
Update to the latest software
version
*Remove all signal connection.
(antenna, external input, ether cable,
etc)
*Insert the USB memory.
SMART CORE LED will change to
white blinking. *After completes, TV
will reboot by itself and turns on.
*Disconnect the USB memory.
WB/Gamma, MURA, CUC data
transfer by Service mode
Reconfirm Software version and
Model name by Service mode
Turn off the TV by remote power key
then reboot the set (AC OFF wait
by remote power key.
149