Error Messages - LG F1496ADT4 Owner's Manual

Troubleshooting guide

■ Error Messages

Symptom
• Water supply is not adequate in area.
• Water supply taps are not completely
open.
• Water inlet hose(s) are kinked.
• The filter of the inlet hose(s) are
clogged.
• Drain hose is kinked or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance
detection and correction system. If
individual heavy articles are loaded
(ex. bath mat, bath robe, etc.) this
system may stop spinning or even
interrupt the spin cycle altogether.
• If the laundry is still too wet at
the end of the cycle, add smaller
articles of laundry to balance the
load and repeat the spin cycle.
• Water overfills due to the faulty
water valve.
• Water level sensor has malfunctioned.
• Over load in motor.
• Check water supply
38
Possible Cause
• Ensure door is not
open.
Solution
Check another tap in the house.
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
Add 1 or 2 similar items to help balance the load.
Rearrange load to allow proper spinning.
Close the door completely.
* If " " is not released, call for service.
Unplug the power plug and call for service.
Close the water tap. Unplug the power plug.
Call for service.
Allow the washer to stand for 30 minutes to
allow the motor to cool; then restart the cycle.
Turn the tap on. If '
unplug power plug and call for service.
' is not realeased,