Advertisement
Battery Replacement
The 5802WXT-2 is powered by a long-life Lithium battery that may be
replaced when a low battery is eventually indicated by the control unit.
NOTE: When replacing the battery, wait a minimum of 30 seconds prior to installing the
new battery.
NOTE: Although water-resistant, please do not immerse in water at a depth below
10cm for more than 1 hour.
1. Remove 4 screws and lift off
cover.
2. Using a small flat-blade
screwdriver remove old
battery.
3. Insert new battery by
placing new battery under
the gold tab and then
pressing down. Ensure the
POS + side of battery is
face up after installation.
Specifications
Unit Dimensions:
LED:
Battery:
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL
WITH WHICH THIS DEVICE IS USED FOR WARRANTY INFORMATION AND FOR
DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
ETL US Listings: HOUSEHOLD BURGLARY WARNING SYSTEM CONTROL UNIT ACCESSORY ETL Canadian
Listings: HOUSEHOLD BURGLARY WARNING SYSTEM CONTROL UNIT ACCESSORY ALSO LISTED FOR USE AS
A SIGNAL APPLIANCE, MISCELLANEOUS CERTIFIED FOR CANADA.
FEDERAL COMMUNICATIONS COMMISSION STATEMENTS
The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions
or User's Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.
FCC/IC STATEMENT
This device complies with Part 15 of the FCC Rules, and RSS 210 of IC. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received,
including interference that may cause undesired operation.
Cet appareil est conforme à la partie 15 des règles de la FCC & de RSS 210 des Industries Canada. Son fonctionnement
est soumis aux conditions suivantes: (1) Cet appareil ne doit pas causer d' interferences nuisibles. (2) Cet appareil doit
accepter toute interference reçue y compris les interferences causant une reception indésirable.
IC MODEL: 5802WXT-2
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
Copyright ! 2011 Honeywell International Inc.
www.honeywell.com/security
SCREWS (4) TYP.
BATTERY
4. Align cover and attach with 4 screws.
1.5" (3.9mm) Diameter
Lights when unit transmits.
3-Volt 2032 Lithium
In ETL installations: 3V Panasonic or SENER
CR2032 only
5802WXT-001-V0
Ê800-09009<Š
INSERT BATTERY
UNDER GOLD TAB
AND PRESS DOWN
5802WXT-002-V0
800-09009 5/11 Rev. C
Advertisement
