Table of Contents
Advertisement
USER MAINTENANCE INSTRUCTIONS
To prevent trouble and poor operating, it is important to check filters and spray arms
at regular intervals.
Keeping the dishwasher
• If you are not using the dishwasher for a long
time, run a Quick & Dry cycle without detergent.
When the cycle is finished, clean the dishwasher
according to the USER MAINTENANCE
INSTRUCTIONS to remove the food debris at
the bottom of the dishwasher and close the door.
Filters
• Remove the lower rack first.
• Turn the mesh filter counterclockwise.
• Take out the mesh filter, upper STS filter and
outer filter.
• We recommend to clean them and run the Quick &
Dry cycle without detergent at least once a week.
• Replace them in the reverse order.
NOTE
• After each cycle, clean the filter for a better
washing result.
• Before starting, check that the filter is
assembled well. If the filter is not assembled
correctly, you might have a poor cleaning
result.
Lower Spray Arm
• Check that the water jet holes are not blocked.
• If cleaning is required, remove the arm by
pulling up.
• Clean the spray arm and replace it pulling down.
• Pull the upper rack forwards.
• Check that the water jet holes are not blocked.
• If cleaning is required, remove the arm by
unscrewing the nut.
• Clean the spray arm and replace it in the
reverse order.
Mesh filter
• A filter is incorporated in the connection of
the valve on the water inlet hose.
Outer filter
If insufficient water flows into the dishwasher,
check that the filter is not blocked.
Upper STS
• Cleaning the filter
filter
- Disconnect the dishwasher
- Turn off the tap.
- Unscrew the inlet hose.
- Remove the filter from
- Clean the filter in the supply
- Refit the filter, making sure
- Reconnect the inlet hose to the tap.
- Turn on the tap.
• If there is a leak, the inlet hose might not be
on securely, or it may have been screwed on
at an angle. Unscrew and reconnect the water
inlet valve correctly.
• Reconnect power supply.
27
27
Upper Spray Arm
Water Inlet
from the mains supply.
Switch off at the mains socket
and remove the plug.
connection.
hose under running water.
it is sitting correctly.
Advertisement
Table of Contents
