Advertisement
INSTRUCTION SHEET
CADDY ROD LOCK Strut Nut
3/8", M8, M10
Step 1
Install CADDY ROD LOCK Strut Nut on to strut
Step 1-1:
Rotate lock nut counter
clockwise until reaches
the fully extended
position on both sides
to enable/free CADDY
ROD LOCK Mechanism
Step 2
Note: Once Step 2 has been completed, the top and bottom parts are tightly held together, which enables
the assembly to spin/slide in the slot without disassembling during transportation. This will preserve the ability of
fine height adjustment in the field.
Step 3
Step 4
Step 4-1:
Tighten lock nut
on both sides
Pentair, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by Pentair or its global affiliates. All other trademarks
are the property of their respective owners. Pentair reserves the right to change specifications without prior notice.
TECHNICAL SUPPORT:
www.erico.pentair.com
Step 1-2: Hand tighten the plastic
stem nut to the bottom housing.
Strut Nut
with insert
Tighten plastic stem nut to fully closed position and then
loosen slightly using tools to allow for free rotation
Threaded rod
Push CADDY ROD LOCK to engage threaded rods
Step 4-3 (Optional): Tighten the top stem nut an additional 1/2 turn
clockwise with 5/8" [16mm] wrench. Hold the bottom housing with
15/16" [24mm] wrench during tightening.
Step 4-2:
Rotate the hex housing to finely tune the strut height
Clockwise = Adjust assembly down
Counter-clockwise = Adjust assembly up
CFS500_D
2 OF 2
Strut Nut
without insert
© 2015 - 2017 Pentair All Rights Reserved
Threaded rod
Advertisement
