Table of Contents
Advertisement
Setting the Clock & Delay Brew
H
H
H
M
M
M
Fig. 1
TO SET THE CLOCK
1
Plug the power cord into an electrical outlet. The clock
will flash on the control panel to indicate that the time
has not been set.
2
Press the H (hour) or M (minute) button until you reach
the current time. (Fig. 1)
3
After 5 seconds the clock will stop flashing and the
clock will be set.
NOTE: If the clock stops flashing and does not display
the correct time of day, pressing the H (hour) or the M
(minute) button at any time will cause the clock to flash
again. You can now re-program the correct time of day
by following the steps above.
NOTE: If you unplug the brewer or in the event of an
extended power loss, you will need to reset the clock
the next time the brewer is plugged in.
TO SET THE DELAY BREW TIME
1
Press Delay Brew. The Delay Brew button will illuminate
and the clock will begin to flash "00:00" or the last
delay brew time that was set. (Fig. 2)
2
While the clock is flashing, press the H (hour) or M
(minute) button to set the time that you would like the
delay brew to begin.
3
Once the proper time has been set, select the size of
the vessel that you would like to brew.
4
Select the Brew Type that you desire from the flashing
buttons. The selected brew type will be lit. (Fig. 3)
9
0800 862 0453
H
M
Fig. 2
Fig. 3
5
Once the time, brew size, and brew type have been set, allow
the Delay Brew to flash and lock in or press the Delay Brew
button to activate the Delay Brew. When the Delay Brew is
activated, the light on the Delay Brew button will illuminate
and an audible signal will play to verify the Delay Brew is set.
6
The Delay Brew time is now set and your Ninja Coffee Bar
will automatically brew at the time you programmed.
NOTE: To deactivate the Delay Brew cycle, press the Delay
Brew button once more and the light on the Delay Brew
button will turn off. Any change to the selected brew size
or starting any other brew will cancel the programmed
Delay Brew.
7
Place the appropriate-sized vessel under brew basket for the
selected size.
IMPORTANT: Make sure the Drip Stop is in the open
position.
Go to www.ninjacoffee.eu for more
information and how-to videos.
Assembly
H
M
Fig. 4
Fig. 4a
®
1
Place the brewer on a dry, clean and level surface.
2
Holding the water reservoir by the grip, twist
anticlockwise to remove. (Fig. 4) Either flip the lid top
over (Fig. 4a) or remove lid by twisting anticlockwise
to remove (Fig. 4b). Fill with water up to, but not
exceeding the Max Fill Line (1.35 L). To replace the
water reservoir, place on top of the base and twist
clockwise until a click indicates it is locked in place.
H
M
Fig. 5
Fig. 4b
Fig. 6
3
Pull the brew basket out and angle up slightly to
remove it from the brewer. (Fig. 5) To reinsert, align
the brew basket with the rails and slide back into the
brewer. (Fig. 6)
4
Once the brew basket is in place, push all the way into
place until you hear a slight click.
H
M
www.ninjacoffee.eu
10
Advertisement
Table of Contents
