Software Install And Registration - Dremel Idea Builder 3D20-01 Operating/Safety Instructions Manual

2610035691 03-18 3D20_3D20 3/8/18 10:35 AM Page 21
1. Go to www.digilab.dremel.com.
2. From a PC: Download and install software
onto your PC.
a. Download the Dremel 3D software from
www.digilab.dremel.com.
b. Click on the file in the folder location that
you downloaded the file. The install
wizard will open.
c. Follow the prompts in the install wizard
to load the software on your computer.
3. From a MAC: Download and install
software onto your MAC.
a. Click Downloads and select Dremel 3D
software. Double click on the zip file and
the the Dremel 3D installer will appear.
b. Double click on the Dremel 3D installer
to make a new window open. Drag the
install file to the APPLICATIONS folder.
c. If the "Drag to Install" window did not
open, locate the Dremel 3D driver in you
device panel. Click on Dremel 3D to
download software.
NOTE: Safari users will not have to unzip
the INSTALLER.DMG file.
d. Click NEXT to launch the setup wizard.
The Dremel 3D software setup wizard
will guide you through the steps to install
the software on your computer. Click
NEXT to launch the setup wizard.
Software Install
1. Ensure power switch is in the off position.
2. Plug your Dremel 3D20 into the computer
with the USB cable.
3. Open software.
4. Turn your Dremel 3D20 on using the
power switch to sync your computer to
your Dremel 3D20.
21
Connecting USB Cable