Advertisement
Contents : 1 x Rustica FireLamp, 1 x flame, 2 x fixing hooks, 2 x wall plugs.
12v 20w red/amber bulb – do not replace with a bulb greater than 20 watts.
Safety.
1)
The lamp must be installed by a professionally qualified electrician.
2)
This unit must be earthed.
3)
Ensure that the mains supply is turned off before fitting the lamp.
4)
This lamp is for indoor use only.
5)
Whilst wall plugs are supplied, the installer must ensure that the
wall fixings are sufficient to take the weight of the lamp. This is
particularly important for hollow walls, such as plasterboard.
6)
The tiles used in this lamp are antiques and need gentle handling.
Do not bang against hard surfaces or chipping or breakage may
occur.
Instructions.
1) Remove the lamp carefully from its packaging and lay it on a flat, non-
scratchable surface.
Rustica Wall Lamp
Safety and Instructions
Safety and Instructions
1
Advertisement
Table of Contents
Summary of Contents for RUSTICA FireLamp
- Page 1 Rustica Wall Lamp Safety and Instructions Contents : 1 x Rustica FireLamp, 1 x flame, 2 x fixing hooks, 2 x wall plugs. 12v 20w red/amber bulb – do not replace with a bulb greater than 20 watts. Safety and Instructions Safety.
- Page 2 4) Now offer the body of the lamp and full-tile up to the wall where required and mark the top hole for fixing. The top of the firelamp unit should be above eye level so that the working parts are not visible once the front half-tile is re-attached.
- Page 3 Keep the flame to the back of the unit and out of the way whilst doing this to avoid damage to it. 10) Once the lamp is symmetrical, the nuts should be fitted to the bolts to hold the tile in place.
- Page 4 This product is not a toy, it is an electrical lighting product and the usual rules must be observed. • Any contact with, or proximity to, water is to be avoided. • The bulb can get hot whilst in use. Allow to cool before touching. •...
Need help?
Do you have a question about the FireLamp and is the answer not in the manual?
Questions and answers