hestan AGCP Series Instructions Manual

Colored panel replacement cabinetry

Download this manual

CABINETRY -

IMPORTANT - READ ALL INSTRUCTIONS BEFORE YOU BEGIN

THE INSTRUCTIONS HEREIN SHOULD BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN.

IF CABINET OR DRAWER IS NEAR AN APPLIANCE, IT MUST BE COMPLETELY COOL AND THE GAS

SOURCE MUST BE SHUT OFF. THE POWER MUST BE DISCONNECTED.

TOOLS REQUIRED:

Flat and Phillips screwdrivers

PART REPLACEMENT - TYPICAL DOOR

1. Unclip door hinge from frame. Consult the

Installation Manual 009798 or 009799 which came

with your cabinet product. If door was part of a

Grill Cart, consult the manual which came with

the cart.

Remove the hinges from the back face of the door

as shown in Fig. 1.

2. Lay the door on a flat surface with a blanket or

towel to protect the door finish. Remove the door

liner by removing all screws as shown in Fig. 2.

COLORED PANEL

REPLACEMENT

Some parts inside your cabinet or drawer have sharp edges. Care must be

taken when handling the various components to avoid personal injury. Wear

gloves when handling.

AGCP SERIES

(VARIOUS PRODUCTS)

FIG. 1

FIG. 2

Need help?

Do you have a question about the AGCP Series and is the answer not in the manual?

Page 1 Fig. 1. FIG. 1 2. Lay the door on a flat surface with a blanket or towel to protect the door finish. Remove the door liner by removing all screws as shown in Fig. 2. FIG. 2 ©2019 Hestan Commercial Corporation...
Page 2 1. For the AGLP cabinet, remove the door by pulling straight up until the door comes off the pins (shown here in red). Panel replacement is the same as step 2-4 in the previous section. DOOR PINS ©2019 Hestan Commercial Corporation...
Page 3 FRAME 2. Lay the drawer face-down on a flat surface with a blanket or towel to protect the finish. Remove the drawer face from the drawer box by removing 10 screws as shown below in red. ©2019 Hestan Commercial Corporation...
Page 4 1. For the AGPTD16 Paper Towel Dispenser, slightly close the door and remove 2 hidden screws (shown in red) and the door stop (shown in green). The door will open further, exposing the inner walls of the box. ©2019 Hestan Commercial Corporation...
Page 5 Fig. 6. 4. Re-assembly is the reverse process. It is recommended to install all screws by hand, and NOT use a drill-driver or screw gun. It is very easy to strip the threaded holes. FIG. 6 ©2019 Hestan Commercial Corporation...
Page 6 You will hear the release levers click. Open and close the drawer a few times to check for proper function and alignment. Don’t forget to re-install the rubber bumpers. ©2019 Hestan Commercial Corporation P/N 030526 REV A...

Agtrc20