Page 1
This document is the application note for the MO300 series modules. Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
Page 2
/ Document creation 24/10/2007 Mise à jour / Major update 13/10/2008 FCC Updates Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
Page 3
Direction des Recherches et des Développements Etablissement de VELIZY VELIZY R&D Center MO300 M2M MODULE APPLICATION NOTE Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document.
3.2.6 Characteristics of the microphone and speaker recommended by SAGEM ...........18 3.2.6.1 Characteristics of the microphone recommended by SAGEM ..................18 3.2.6.2 Characteristics of the dual mode speaker recommended by SAGEM ................18 ..............................18 ETWORK 3.3.1 Network LEDs connection..........................19 3.3.2...
Page 5
IROSE COAXIAL CONNECTOR 11.3 ......................45 NNEXE PRING CONTACT FOR ANTENNA LABEL..................................46 Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
The aim of this document is to describe some examples of hardware solutions for developing some products around the SAGEM MO300 M2M Module. Most part of these solutions are not mandatory. Use them as suggestions of what should be done to have a working product and what should be avoided thanks to our experiences.
Note: These two ways are exclusives, never use both solutions at the same time. This is mandatory. Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication...
MO300 pull up raise the signal to high level (1.8V) Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
SIM card presence detector cannot be used with the SIM holder on the back of the MO300. The SIMCD signal is therefore not used in that case. Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
Close view of the components area: Figure 12 Zoom on components area SAGEM can provide a suppliers component codes list on request Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication...
The MO300 can manage an external microphone (MICP/MICN) and external speaker (32 ohms SPKP/SPKN) in differential mode. Thus, one receiver and one microphone can be connected to the module with the following characteristics (see SAGEM references): Receiver 32 ohms up to 120 ohms Microphone accepting the polarisation described below (FET Buffer + Open Drain).
Figure 16 EMC& ESD protections for speaker in case of need Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
MCSI Clock : 520 kHz Voltage : 1.8V More details can be given on request. Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
3.2.6 Characteristics of the microphone and speaker recommended by SAGEM 3.2.6.1 Characteristics of the microphone recommended by SAGEM Item to be inspected Acceptance criterion Sensitivity -32 dB SPL +/- 3 dB (0 dB = 1 V/Pa @ 1kHz) or...
More details can be found in AT document referenced [ 2 ]. Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
In case of batteries, it is mandatory to use Li-Ion or Li-Polymer batteries. NOTE: The MO300 M2M module does not manage the charge of any kind of batteries. V24 UART The MO300 module feature a V24 UART interface plus a USB2 OTG interface to communicate with the Host through AT commands or for easy firmware upgrading purpose.
In slave mode, the MO300 is answering to the customer application which is the Master of the communication. Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication...
Figure 24 USB Connection between MO300 and host To use USB link between Host and MO300, specific SAGEM USB drivers are needed and available on SAGEM www site and on request. As soon as USB link is detected by the MO300 module, the AT command responses are sent on USB link and RS232 - UART1 interface is de-activated.
(deep discharge) V backup = 2.8 V If the recommended schematic is implemented by the customer, SAGEM will set a dedicated parameter in the software which will automatically manage the charging function. The advantages of this management are: •...
Backup Battery technology recommended 3.8.3.1 Manganese Silicon Lithium-Ion rechargeable Battery Sagem does not recommend to use this kind of technology because of the following drawbacks: • the maximum discharge current is limited (Shall be compliant with the module characteristics) •...
The returned value is on 10 bits converted to decimal. 3.12 Micro-wire Bus The microwire bus is available but the client has to ask SAGEM to develop the driver and the specific application related the connected device. 3.13 Antenna detection Antenna detection can be provided if following criteria are met : •...
MOD_ON_STATE can be used as feedback to stop the pulse: Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
USB connexion to communicate again with the MO300 module. Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
The module's firmware can be upgrade over serial or USB links. To proceed, SAGEM recommends that products based on SAGEM modules provide a direct access to the module serial link or USB through an external connector or any mechanism allowing the upgrade of the module without opening the whole product.
Uncouple microphone and speaker by capacitor or Varistors in parallel of each wire of these devices Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication...
In case of EMC issue due to a headset audio device, the solution may consist in inserting a filter on the wires of the microphone and of the speaker. Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
50 Ω line matching (between module and MAIN board, and with RF test point) • SAGEM strongly recommends to solder the spring contact on the whole surface instead of only 2 points Keep matching circuit on MAIN board but with direct connection in the first step – it could be necessary to make...
FPC have to be a shielded one Other recommendations – Tests for production/design SAGEM guarantees the RF performances in conductive mode but strongly recommends to make RF measurements in an anechoide chamber in radiated mode (tests conditions for FTA) : the radiated performances strongly depend on radio integration (layout, antenna, matching circuit, ground area…..).
Reduce as much as possible the number of electronics components (loss of quality, more dispersion) • Audio tracks must be larger than 0.5 mm Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
Figure 31 Layout of audio differential signals on a layer n Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
8 layers may be necessary for a correct and safe layout. Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
The plug is mounted on the MO300 board and the receptacle should be mounted on the main board (which the module is connected to). Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
Metal particles presence in the mechanical disturbs strongly the radio performance of the module. For example, the minimum sensitivities levels are not guarantied in case of such use. Moreover, Sagem does not recommend to have metallic particles especially in the antenna area.
MO300. Their references are mentioned and their specifications are available at the end of this document. 11.1 Annexe: Molex Board to Board connector Dimensions and references: Pin Number References MOLEX 54150-0878 Sagem reference : 189576119 Dimension 23.9 19.5 20.5 Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document...
Page 43
Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...
This label can use wording such as the following: “Contains Transmitter module FCC ID: VW3MO300QBM” or “Contains FCC ID: VW3MO300QBM”. END OF DOCUMENT Note d’étude / Technical document : URD1 – 5625.1 – 006 / 69796 Edition 03 Document Sagem Communication Reproduction et divulgation interdites Sagem Communication document. Reproduction and disclosure prohibited...