White-Westinghouse WNGB90JGR User Manual page 36

INSTALLATION
Changing from natural gas to
liquid gas
1. Fully tighten the bypass screw.
2. Put the knob back.
Changing from liquid gas to
natural gas
1. Unscrew approximately one turn the
bypass screw position A.
2. Put the knob for the hob back.
3. Connect the appliance to the electricity.
WARNING!
Put the mains plug into the mains
socket only if all parts are back into
their initial position. There is a risk
of injury.
4. Light the burner.
Refer to "Hob - Daily use" chapter.
5. Turn the knob for the hob to the
minimum position.
6. Remove the knob for the hob again.
7. Screw on slowly the bypass screw till
the flame becomes minimum and
stable.
8. Put the knob for the hob back on.
Oven injector replacement
1. Remove the bottom plate of the oven
cavity to get access to the oven burner .
2. Carefully remove from the burner the
thermocouple A. Next remove the spark
plug B.
36
3. Unscrew the screw and slowly pull out
the burner.
1
4. Release the burner injector with a 7 mm
socket spanner and replace it with a
right one.
Assemble the burner in a revers sequence.
Replace the gas type sticker near the gas
supply ramp with the one related to the new
gas type.
A
B
2