S&S Worldwide Hanging Hoops Target W8730 Assembly Instructions

W8730 Hanging Hoops™ Target
Assembly Instructions

Components:

A – Top Assembly – 1
B1 – Short Extensions – 2
B2 – Long Extensions – 2
C – Vertical Post – 6
D – Horizontal Post – 4
E – T Connector – 6
F – Corner – 2
G – All Star Target (blue) – 1
H – Super Target (red) – 1
I – Way-To-Go (white) – 1
Image #1
Image #2
Image #3
Note: The images all show the locking buttons as facing the forward for added
clarity. During actual assembly of the structure the buttons and corresponding holes
should be on the back side of the target to avoid being hit by balls during play.

Assembly:

1. Insert an extension (B1 or B2) into each side of the top assembly until the button pops
through the corresponding hole in the top assembly. The longer extensions (B2) are
recommended for rims that are 9 or 10 feet high, the shorter extensions (B1) for those that are 8 feet or less. (image 1)
2. Slide a T connector (E) over the opposite end of each extension. (image 1)
3. Thread a horizontal post (D) through the 3 loops on the top of the All Star Target (G). (image 2)
4. Insert the ends of the horizontal post above into the T connectors. (image 2)
5. Slide a Vertical Post (C) into each of the side pockets on the All Start Target until the buttons on the post pop out of the
corresponding holes in the T connectors. (image 3)