Checking Basic Router Functions - NETGEAR WGR614v5 Setup Manual

– Some cable modem services require you to use the MAC address of the computer
registered on the account. If so, in the Router MAC Address section of the Basic Settings
menu, select "Use this Computer's MAC Address." Click Apply to save your settings.
Restart the network in the correct sequence.
• Check the router status lights to verify correct router operation. If the Power light does
not turn solid green within 2 minutes after turning the router on, reset the router according to
the instructions in

Checking Basic Router Functions

After you turn on power to the router, check that the following sequence of events has occurred:
1. When power is first applied, verify that the power light is on (see
an illustration).
2. Verify that the power light turns amber within a few seconds, indicating that the self-test
procedure is running.
3. After approximately 20 seconds, verify that:
a. The color of the power light changes to green.
b. The LAN port lights are lit for any local ports that are connected.
If a port's light is lit, a link has been established to the connected device. If a LAN port is
connected to a 100 Mbps device, verify that the port's light is green. If the port is 10
Mbps, the light will be amber.
c. The Internet port is connected and its light is lit.
4. If you have enabled WPS security, verify that the Push 'N' Connect status light stops blinking
and changes to green (otherwise the Push 'N' Connect status light should be off).
If the correct behavior does not occur, check for a remedy from the following list:
• Power Light Not On. If the Power and other lights are off (see
Router" on page
– Make sure that the power cord is properly connected to your router and that the power
adapter is properly connected to a functioning power outlet.
– Check that you are using the power adapter supplied by NETGEAR for this product.
If the error persists, you have a hardware problem and should contact technical support.
• Power Light Blinks Green Slowly and Continuously. The router firmware is corrupted.
Troubleshooting
"Restoring the Default Password and Configuration Settings" on page
12), check the following:
"Front Panel" on page 2
"Connecting Your Wireless
34.
for
25