Child Lock; Progress Of Programme - Beko WTB740E1W User Manual

4.6.11 Child Lock

Use Child Lock function to prevent children from tampering with the machine. Thus you
can avoid any changes in a running programme.
C
If the Programme Selection knob is rotated when the child lock is active, "Child Lock Enabled
LED" will flash 3 times. The Child Lock does not allow any change in the programmes or the
selected speed.
Even if another programme is selected with the Programme Selection knob while the Child
Lock is active, previously selected programme will continue running.
When the Child Lock is active and the machine is running, you can switch the machine to
Pause mode without deactivating the Child Lock by turning the Programme Selection knob to
On / Off position. When you turn the Programme Selection knob afterwards, the programme
will resume.
To activate the Child Lock:
Press and hold Speed and Delayed Start buttons for 3 seconds. While you are holding for
3 seconds, the "Child Lock Enabled LED" will flash. You can release the buttons when the
LEDs become permanently on.
To deactivate the Child Lock:
Press and hold Speed and Delayed Start buttons for 3 seconds while any programme is
running. While you are holding for 3 seconds, the "Child Lock Enabled LED" will flash. You
can release the buttons when the LED turns off completely.
C
In addition to the method above, to deactivate the Child Lock, switch the Programme
Selection knob to On / Off position when no programme is running, and select another
programme.
Child Lock is not deactivated after power failures or when the machine is unplugged.

4.6.12 Progress of programme

Progress of a running programme can be followed from the Programme Follow-up
indicator. At the beginning of every programme step, the relevant indicator light will turn
on and light of the completed step will turn off.
You can change the speed settings without stopping the programme flow while the
programme is running. To do this, the change you are going to make must be in a step after
the running programme step. If the change is not compatible, relevant lights will flash for 3
times.
C
If the machine does not proceed to the spinning step, the Rinse Hold function might be
active or the automatic unbalanced load detection system might be activated due to the
unbalanced distribution of the laundry in the machine.
28 / EN
Washing Machine / User's Manual