BJ Live BJ Enabler 1R-LV User Manual

BJ-232
BJ Enabler 1R-LV
User's guide
www.bjliveat.com

1. Description of the device

This Enabler with one relay switched
contact and powered with low voltage, is
designed to activate elements such as
motored doors, one-light circuit,
warning, the doorbell, etc.
Switch control
input
Operating mode
jumper JP1
(back side)
RF Code
selector
Relay
(back side)
output
Power
Supply
input
Fig. 1: BJ Enabler 1R-LV
You can activate the Enabler remotely
using any of the BJ System's remote
controllers or directly via
switches.

2. Technical data

RF Frequency: 433MHz
Power supply: 12-24Vdc / 12Vac
Output: 1 COM relay contact
Section of the power cables: 1,5mm
Maximum section in load circuit:
2
2,5mm
Dimensions: 50x50x25mm
Maximum loads:
• Resistive loads (light,
halogen lamps...): 12A
• Inductive loads:
3.5A/350W/cosϕ=0,4.

3. Pre-installation

For correct installation, the Enabler must
be fitted in a sealed box that provides
sufficient space, absence of dust and
a
humidity and isolation
contact with people.
To install the Enabler you must carry the
Enabler's power cable, load cable and
switch's cable to the box where it will be
installed.

4. Installation

For a proper installation of the device
see figure 2:
External switch
Mode
operating
jumper
RF code
selector
special
Control
input
Relay output
2
12/24Vdc
12 Vac
NC C NA
bulbs,
Power supply
load control
CAUTION!
Electrical installation may only
be carried out by a qualified
electrician!
from direct Do not make any unauthorized
alterations or modifications to the
unit.
The relay contact is only suitable
for low voltage power supply
(12-24 V dc/ 12V ac)
Observe the
instructions for the device to be
operated.
CAUTION!
An error in the connections may
cause serious damage to the
device or the installation, or
harm to the operator.
IMPORTANT:
technical data to check the type and
maximum loads
connected to the Enabler. Power
cables must be stripped a distance
of 6mm.
Once the Enabler's
made and before connecting the device
to the power supply, you must choose
the position on the "RF code selector"
(see figure 1).
To control the load via an alternative
access switch, connect the two cables of
the switch to the Control input.

5. Operating modes

This Enabler is designed for switching
devices in two
modes:
manufacturer's
See the device
that can be
connections are
selectable operating