Advertisement
Thank you for purchasing this Jacques tripod floor lamp. Please read the instructions carefully
before use to ensure safe and satisfactory operation of this product.
Warnings!
To prevent electric shock, switch off the mains supply before maintaining this product.
Ensure other persons cannot restore the electricity supply without your knowledge.
Always use the correct bulb type with the correct power rating as indicated in the
'specifications' section.
Never exceed the max. power rating.
A
B
C
D
Assembly
1.
Remove all protective packaging (Carton 1 and 2)
IMPORTANT NOTICE
Plastic/plastic bags can be dangerous. To avoid danger and suffocation keep away from
babies and children.
2.
Place the lamp with the feet of the legs on a stable surface, ensure that the legs are
evenly spaced to approx. 45-50cm apart at the feet.
3.
Locate the stabilising arm A on the inside of each leg and raise to bring all 3 together so
that the locating holes line up, you will find the provided bolt and wing nut attached to
one of the arms.
4.
Unscrew the wingnut B and gently push the provided bolt through the top of all 3 holes
and secure in place with the wing nut.
5.
Adjust the legs individually approximately 5-10cm at any one time until the desired
height is reached by loosening the wing nut C
6.
Slide one leg out to the required length and re-secure with the wing nut
7.
Repeat this process for all three legs ensuring that the wing nuts are secured hand tight.
8.
Remove the shade ring D, add the shade (supplied in carton 2) and secure with the
shade ring.
Care instructions
Ensure that the product has been switched off and allowed to cool, using a soft dry cloth
Wipe clean lamp base only, do not wipe the bulb.
Before moving ensure the product is switched off and allowed to cool to avoid damage lift the
item by holding by the base only.
Advertisement
