Equip 650329 Installation Manual

Equip 650329 Installation Manual

32"-70" motorized tv ceiling mount bracket

Advertisement

32"-70" Motorized TV Ceiling
Mount Bracket
VESA Compatible
70"
650329
200x100 200x200 200x400
35kg
300x200 300x300 400x200
MAX
(77lbs)
400x300 400x400 600x400
RATED
FLAT/CURVED
INSTALLATION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 650329 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Equip 650329

  • Page 1 32"-70" Motorized TV Ceiling Mount Bracket VESA Compatible 70" 650329 200x100 200x200 200x400 35kg 300x200 300x300 400x200 (77lbs) 400x300 400x400 600x400 RATED FLAT/CURVED INSTALLATION MANUAL...
  • Page 2 A (x1) B (x1) C (x1) D (x2) E (x2) F (x2) G (x1) H (x1) I (x4) J (x2) K (x4) L (x4) M (x4) N (x4) O (x4) P (x1) M6x25 M4x8 M-A (x4) M-B (x4) M-C (x4) M-D (x4) M5x14 M6x14...
  • Page 3 WARNING: • Installers are responsible to provide hardware for other types of mounting situations. • Installers must verify that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components. 55mm ø 4.5mm 60mm ø...
  • Page 4 200mm 400mm 600mm Remove the bottom screws from the VESA plate and keep the four screws for use later. ≥ 5 m...
  • Page 5 Too long Too Short Note: the leveling knob will touch the ceiling and balance the mount when the mount fold up to the minimum position against the ceiling.
  • Page 6 ≥15mm Use the cable ties to hold WARNING: the cables in place. Anything is not allowed to pass Note: Leave slack in the through the mount motion space. cables for arm movement.
  • Page 7 WARNING: Do not open the electrical cover please. WARNING: Never operate the unit without a TV installed. Remote Control Operation Instructions A. Button Functions 1.Upward/Downward Movement Press the " " button, the TV mount will move upward to the lowest-profile position against the ceiling. Press the "...
  • Page 8: Error Indication

    C. Coding of Remote Controller and Control Box Step 1: When the mount is powered on, press the small button on the control box with a thin tool as shown. The unit emits a beep, indicating that the control box is on standby for program coding. Step 2: Press the “...
  • Page 9: Electrical Safety Instructions

    Note: Read the entire instruction manual before you start installation and assembly. The product is powered by electricity. In order to avoid burns, fire and electric shock and make sure the safe and correct use of the system and maintain the longevity of the overall construction and the built-in electronics, please read the instructions carefully.

Table of Contents