Page 2
TABLE OF CONTENTS INTENDED USE/INDICATIONS FOR USE GENERAL WARNINGS TECHNICAL SPECIFICATIONS BATTERY CHARGING INSTRUCTIONS CLEANING INSTRUCTIONS DISPOSAL/RECYCLE TROUBLESHOOTING LIMITED WARRANTY SYMBOLOGY LIT 232 ® CUDA Surgical Rev. - (English) Date of Revision:01/26/18 Page 2 of 6...
Page 3
INTENDED USE The LLS-3736-2, 2-bay battery charger is intended to charge 2054-style, smart, li-ion ® battery packs supplied by ST Technologies WARNINGS • Upon initial receipt and before each use, inspect each battery and charger for damage. Do not attempt to charge a damage battery. Do not attempt to operate the charger if the cord and/or plug appear to be damaged, such as cuts, bent pins or contacts, and/or cracks.
Page 4
TECHNICAL SPECIFICATIONS Item Specification Input 2.5A max Output 16.8V 3.3A max Operating Temperature 41⁰F to 95⁰F (5⁰C to 35⁰C) Storage Temperature 14⁰F to 140⁰F (-10⁰C to 60⁰C) Operating Humidity 10% to 90% Storage Humidity 5% to 95% Dimension (without battery adaptor) (LxWxH) 8.9in x 3.7in x 6.1in Weight (without battery adaptor) 1.35lbs...
Page 5
NOTE: • If a red LED is lit on a bay, the battery of the corresponding bay should be removed from the charger and its contacts checked. Install the battery pack again. If the red LED illuminates again, remove the battery pack from the charger and contact Sunoptic Technologies for service.
Page 6
LIMITED WARRANTY Your 2-bay battery charger carries a 3-years warranty from the date of shipment on workmanship and all defects of material except batteries. Should your product prove to ® have such defects within three years from the date of shipment, ST Technologies will repair or replace the product or component part without charge.
Need help?
Do you have a question about the LLS-3736-2 and is the answer not in the manual?
Questions and answers