• Do not leave the system in any place that could be damaged by children, pets, pests, or liquids. If you suspect your system of devices is damaged, contact customer service at Help@Joovv.com. • Do not install system near heated surfaces such as nearby fireplaces or ceramic heaters.
Table of Contents Notices ................................2 Parts List ...............................4 Door Configurations ..........................5 1 Pole Setup ..............................8 2 Pole Setup .............................. 15 Setting Slider Mount ..........................16 Oversize Door Kit Assembly ....................... 17 Adding Spacers to Mounted devices ....................18 Revision History ............................19 Warranty ..............................
joan, these two views are “rear” views of the brackets. not sure which Rick would rather show. Parts List top bracket bottom bracket Pole Upright 1 Pole Kit Top Assembly Bottom Assembly M6 Screw Slider Mount 4mm Allen Key Cover Cap 25”...
Page 9
Step 1 Step 2 Install the Slider Mount(s) Connect top and bottom assembly attachment to Pole Upright. Turn to Pole Upright using M6 Screw with knob counterclockwise ~1 turn and Allen Key. pullout to slide on the pole. TURN TO LOOSEN PULL OUT WARNING!
Page 10
Step 3 Install Door system on door as shown in the illustration below. Door side view...
Page 11
Step 4 To secure the Bottom Assembly hook to the door, pull the strap through the buckle to tighten. Once pulled tight, roll up the excess strap and hide using the Cover Cap. For easier access keep strap loose until device, AC power cable(s) and spacers are installed.
Page 12
Step 5 To adjust the Slider Mount, turn the knob counterclockwise ~1 turn and pull out. Slide the mount up or down based on your desired height. To secure the Slider Mount tighten the knob by turning it clockwise until hand tight. PULL OUT TURN TO LOOSEN...
Page 13
Step 6 While holding the device as shown below, align the device over the Slider Mount keyholes and slide the device down onto the Slider Mount to secure.
Page 14
Step 7 To remove the Solo or Mini Device from the Slider Mount, follow the steps TO MOVE LOCATION OF A SOLO OR MINI UNIT ON THE DOOR MOUNT: illustrated below. STEP 2 STEP 1 LIFT DEVICE WHILE PUSH HANDLE PUSHING SAFETY HANDLE LIFT PUSHING...
2 Pole Setup 1 Pole To configure a 2 Pole Setup, repeat steps 2 Pole found on page [8] for the 1 Pole Setup. After completing your setup and installing your devices, refer to page [18] for installing the alignment plugs. Reference the Mini &...
Setting Slider Mount on Pole for Specific Configurations For the Duo and Half Max For the Duo configuration set the configuration set the top Slider Mount bottom Slider Mount so 5 holes are so 11 holes are showing from the top showing from the bottom of the Pole of the Pole Upright.
Door Hook 96’’ and thicker than 1- 3/8’’ up to 1 3/4’’ 1 7/16” 1 3/4” Joovv offers an Oversize Door Kit that can be purchased at Joovv.com. To install Oversided Door Hook, follow instructions illustrated below. Remove top Door Hook from For doors that are taller than 84”...
Spacers help keep the separate devices aligned and immobile. See illustration below for Spacer insert locations. When using the spacer kit with the Joovv Mini, utilize the included O-Rings with your spacer kit before inserting. Slide the O-Ring onto the spacer plug...
Ver.0 Release to market Warranty All Joovv mounting accessories are covered by a 2-year limited warranty. Please visit our website at https://joovv.com/pages/warranty for details of the limited warranty. To register your product, visit https://joovv.com/pages/warranty for instructions. Failure to register will not affect your limited warranty rights.