AEG L7FEE941Q User Manual page 43

• The appliance makes an unusual
noise because of the blockage of the
drain pump.
• The display shows the alarm code
.
WARNING!
• Do not remove the filter
while the appliance
operates.
• Do not clean the pump if
the water in the
appliance is hot. Wait
until the water cools
down
Proceed as follows to clean the pump:
1. Open the pump cover.
1
2. Place a suitable bowl below the drain
pump access to collect the water that
flows out.
3. Open the chute downwards. Always
keep a rag nearby to dry up any
water spillages when removing the
filter.
4. Turn the filter 180 degrees in anti-
clockwise direction to open it,
without removing. Let the water flow
out.
5. When the bowl is full of water, turn
6. Repeat the steps 4 and 5 until the
7. Turn the filter anti-clockwise to
2
8. If it is necessary, remove fluff and
9. Make sure that the impeller of the
10. Clean the filter under the water tap.
the filter back and empty the
container.
water stops to flow out.
remove it.
1
objects from the filter recess.
pump can rotate. If it does not
rotate, contact the Authorised
Service Centre.
ENGLISH 43
2