Toro TurfMaster 22207 Manual page 34

1. Trailing shield
10. Rotate the idler pulley over the access hole on
the transmission by using a socket wrench to
turn the idler-pulley nut clockwise.
1. Socket wrench
2. Idler-pulley nut
11. While you are holding the idler pulley over
the access hole on the transmission, insert a
Figure 48
2. Trailing-shield bolts
Figure 49
3. Access hole
4. Screwdriver
screwdriver through the access hole to catch a
rib on the idler pulley.
g280624
1. Screwdriver through
access hole
2. Access hole
12. Use the screwdriver to hold the idler pulley out
of the way until you are done installing the new
transmission belt.
13. From the front of the machine, remove the belt
from the engine pulley and then remove from
the transmission pulley.
Installing the Transmission Belt
1. While the idler pulley is pulled out of the way,
install the new transmission belt placing the belt
over the transmission pulley first and then over
the engine pulley.
2. Remove the screwdriver from the access hole in
the transmission to return the idler pulley to its
tensioned position.
3. Use the rear-viewing window, located under the
rear-discharge deflector, to ensure that the new
transmission belt is positioned correctly.
4. Install the trailing shield using the 2
trailing-shield bolts removed in Step
Removing the Transmission Belt (page
5. Install the rear-viewing window, located
g281194 under the rear-discharge deflector, using the
corresponding bolt removed in
the Transmission Belt (page
32
Figure 50
3. Idler pulley
4. Transmission belt
9
8 of Removing
31).
g280736
of
31).