Subscribe to Our Youtube Channel
Related Manuals for SSP MLC141
Summary of Contents for SSP MLC141
- Page 1 INSTRUCTION MANUAL Portable Cut-Off MLC141 012154 DOUBLE INSULATION IMPORTANT: Read Before Using.
- Page 2 ENGLISH (Original instructions) SPECIFICATIONS Model MLC141 Wheel diameter 355 mm Hole diameter 25.4 mm No load speed (min 3,800 Dimensions (L x W x H) 500 mm x 280 mm x 620 mm Net weight 16.7 kg Safety class • Due to our continuing program of research and development, the specifications herein are subject to change without notice.
- Page 3 Dress properly. conditions that may affect its operation. A guard or Do not wear loose clothing or jewellery, they can other part that is damaged should be properly be caught in moving parts. Rubber gloves and repaired or replaced by an authorized service non-skid footwear recommended...
- Page 4 14. Use the cutting edge of the wheel only. Never For tool with lock button use side surface. To start the tool, simply pull the switch trigger. Release 15. If the wheel stops during the operation, makes the switch trigger to stop. an odd noise or begins to vibrate, switch off For continuous operation, pull the switch trigger and then the tool immediately.
- Page 5 The original spacing or interval between the vise and the ASSEMBLY guide plate is 0 - 170 mm. If your work requires wider spacing or interval, proceed as follows to change the spacing or interval. CAUTION: Remove the two hex bolts which secure the guide plate. Always be sure that the tool is switched off and •...
- Page 6 If you use a spacer block which is slightly narrower than Securing workpiece the workpiece as shown in the figure, you can also utilize the wheel economically when worn down the wheel. 1. Vise plate 2. Vise nut 1. Diameter of 3.
- Page 7 Replacing carbon brushes Workpiece shape 1. Limit mark Cutting angle 115 mm 119 mm 001145 Remove and check the carbon brushes regularly. 115 mm 106 mm Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time.
- Page 8 Makita Corporation Anjo, Aichi, Japan www.makita.com 885056B937...
Need help?
Do you have a question about the MLC141 and is the answer not in the manual?
Questions and answers