Page 1
Rudder Installation Instructions Thank you for purchasing a rudder kit for your Bluefin kayak. We hope you’ll love it! See full instructions at pakayak.com/rudder Rudder Kit Contents: Tools needed: Drill 3/16 inch drill bit 1/8 inch drill bit 1/4 inch drill bit...
Page 2
Using 1/4 inch drill bit, drill hole in center of steering line locations on Section 6 hull. Install rubber grommet in each hole. Install rudder steering lines by threading the 57 inch long lines through grommets. Tie overhand knot in each end after threading through grommet.
Page 3
Thread line nearest to the third hole back through hole to lock line on rudder. Wind lines on each side of the rudder and install in rudder bracket as shown. Be sure blade is facing correct position and the lines are on opposite sides of the blade and running in opposite directions around hub.