Subscribe to Our Youtube Channel
Related Manuals for dynarex 10702
Summary of Contents for dynarex 10702
- Page 1 Reorder No. 10702 Manufactured for: Dynarex Corporation 10 Glenshaw Street Orangeburg, NY 10962 USA • www.dynarex.com Made in China Sit-to-Stand Electric Patient Lift...
-
Page 2: General Information
Unless the lift is to Stand Electric Patient Lift. For the safety Lift (Reorder no. 10702) is intended for be used immediately, retain boxes, containers, and packing materials for use in storing until use of patient lift is required. - Page 3 ASSEMBLING THE PATIENT LIFT Assembling the boom to the mast Assembling the electric actuator Assembling the knee support to the boom 1. Remove the shoulder bolt, bushing and Slide knee support onto the leg support Assembling the mast to the base nut fastened to the boom mounting bracket and use the plunger pin to adjust 1.
-
Page 4: Equipment Operation
Assembling the control box Installing the shifter handle EQUIPMENT OPERATION to the mast 1. Line up the shifter handle opening with OPERATING THE PATIENT LIFT Raising/lowering the the threaded connector at the base. 1. Temporarily remove the screw on electric patient lift the mast mounting bracket for the 2. -
Page 5: Lifting The Patient
Activating the emergency stop Charging the battery LIFTING THE PATIENT Press the RED emergency button on the It is recommended that the battery should PREPARING THE LIFT FOR USE 2. With the sling securely attached to the control box to stop the boom assembly be recharged daily to prolong battery life. -
Page 6: Troubleshooting Guide
Patient lift feels loose. Mast/base joint loose. Refer to page 4. negligence, accident or improper If you have a question about your Dynarex Tie-rods are loose. operation, maintenance or storage device or this warranty, please contact an Casters/brakes noisy or stiff. - Page 7 R191002...
Need help?
Do you have a question about the 10702 and is the answer not in the manual?
Questions and answers