Quoizel TU8603BNLED Assembly Instruction Sheet

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Bulb Recommended: (3) LED G9 4.5W Bulbs
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Please go to Quoizel.com to see the G9 LED bulb specifications provided with your fixture.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
Inner Backplate
A
x 1
Lock
B Screw
x 4
LED G9 Bulb
C
x 3
-
STEP 1 Install Inner Backplate
A. Race all supply wires through the
Inner Backplate (A) as shown.
Attach Inner Backplate (A) to Outlet
Box with the head of Green Ground
Screw facing you. Secure it with
Outlet Box Screws (not included).
Tighten until snug.
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires between Inner Backplate (A) and
Fixture Body (D).
White wire
from supply
Black wire from
supply (or Red)
Ground wire
from supply
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
2016 QuoizelInc.
Assembly Instruction Sheet #IS-TU8603
For Styles TU8603BNLED and TU8603CLED
for product cleaning tips. Go to the
20-30 minutes
Fixture Body
D
x 1
Shade
E
x 3
Socket Collar
F
x 3
Supply Wires and
Ground Wire
Outlet Box
A
Outlet Box Screw
Figure 1
(not supplied)
White wire
from fixture
Black wire
from fixture
Ground wire
from fixture
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
Care + Maintenance selection.
-
STEP 3 Install Fixture Body
A. Place the backplate of the Fixture Body (D) onto the Inner Backplate
(A) and secure with Lock Screws (B). Hand tighten until snug with
screwdrivers.
STEP 4 - Install Shade and Bulb
A. Place Shade (E) over Socket and secure with the Socket Collar (F).
Hand tighten until snug.
B. Install either the G9 Xenon bulb as specified (not provided) or install
the G9 LED bulbs (provided) if the fixture purchased is the LED
model.
Note: This fixture is rated to use 60W maximum G9 Xenon bulbs.
You may use a lower wattage G9 Xenon or if you purchased the LED
model it is supplied with G9 LED bulbs.
Your fixture is now assembled and ready to use. Enjoy!
Figure 2
1of2
_R1
B
A
A
Figure 4
RevisedDate:2016-06-08
D
Figure 3
C
F
E
Socket