Related Manuals for Esco ETS-Lindgren 3303
Summary of Contents for Esco ETS-Lindgren 3303
- Page 1 Model 3303 Rod Antenna (Model 3305 E-Field Shielding Effectiveness Test Kit) MANUAL © EMC TEST SYSTEMS, L.P. – OCTOBER 2002 REV B– PN 399047...
- Page 2 MODEL 3303 ROD ANTENNA EMC Test Systems, L.P. reserves the right to make changes to any products herein to improve functioning, design, or for any other reason. Nothing contained herein shall constitute EMC Test Systems, L.P. assuming any liability whatsoever arising out of the application or use of any product or circuit described herein.
-
Page 3: Table Of Contents
MODEL 3303 ROD ANTENNA Table of Contents INTRODUCTION..........................1 3305 A ........................1 ODEL NTENNA STANDARD CONFIGURATION ......................2 OPTIONS ............................... 2 ASSEMBLY AND MOUNTING......................3 OPERATION ............................3 TYPICAL DATA............................ 4 MODEL 3305 SYSTEM SETUP......................5 ..... 5 UGGESTED ROCEDURE FOR EASURING LECTRONIC... - Page 4 MODEL 3303 ROD ANTENNA © EMC TEST SYSTEMS, L.P. – OCTOBER 2002 REV B – PN 399047...
-
Page 5: Introduction
MODEL 3303 ROD ANTENNA Introduction INTRODUCTION The Model 3303 Rod Antenna is a passive broadband electric field monopole transmitting antenna that has a frequency range of 1 kHz to 30 MHz. It features manual band switching between 0.001-5 MHz and 5-30 MHz. Maximum power handled by Model 3303 is 1 The base of this antenna is constructed of aluminum, providing both strength and portability. -
Page 6: Standard Configuration
Standard Configuration MODEL 3303 ROD ANTENNA STANDARD CONFIGURATION • Adjustable monopole element • Model 3003 antenna base has a built-in manual band switch and Type N connector • Counterpoise (60 cm) • Base configured to accept ETS-Lindgren or other tripod mounts with standard ¼”-20 threads •... -
Page 7: Assembly And Mounting
MODEL 3303 ROD ANTENNA Assembly and Mounting ASSEMBLY AND MOUNTING IMPORTANT: During the assembly and mounting of this unit take care not to cross thread any connections as permanent damage to the antenna could result. To assemble the Model 3303 antenna, thread the stainless steel rod into the receptacle at the top of the base unit. -
Page 8: Typical Data
Typical Data MODEL 3303 ROD ANTENNA TYPICAL DATA © EMC TEST SYSTEMS, L.P. – OCTOBER 2002 REV B – PN 399047... -
Page 9: Model 3305 System Setup
MODEL 3303 ROD ANTENNA Model 3305 System Setup MODEL 3305 SYSTEM SETUP SUGGESTED TEST PROCEDURE FOR MEASURING ELECTRONIC FIELD SHIELDING EFFECTIVENESS Set the transmitting and receiving antennas, 24 inches + thickness of screen room wall, apart from each other. Set up equipment as shown in Figure 1. - Page 10 Model 3305 System Setup MODEL 3303 ROD ANTENNA CAUTION: Be sure to reduce amplifier power to near zero watts before band switching the 3303. Reference: NSA 65-6 MIL-STD-285 © EMC TEST SYSTEMS, L.P. – OCTOBER 2002 REV B – PN 399047...
- Page 11 MODEL 3303 ROD ANTENNA Model 3305 System Setup © EMC TEST SYSTEMS, L.P. – OCTOBER 2002 REV B – PN 399047...
- Page 12 Model 3305 System Setup MODEL 3303 ROD ANTENNA Table 1. Electric Field Shielding Effectiveness Measurement Frequency NSA 65-6 Approximate Maximum Minimum Wattage Required Shielding Attenuation for to meet NSA 65-6 (Electric Field) Electric Field attenuation that can be specifications measured with this set up Band 1 1 kHz...
-
Page 13: Specifications
MODEL 3303 ROD ANTENNA Specifications SPECIFICATIONS ELECTRICAL Frequency 1 kHz – 30 MHz Maximum Continuous Power 300 W Peak Power 1 kW Impedance (nominal) Varies with frequency Connector Type N female PHYSICAL Base Width 7.6 cm (3.0 in) Base Depth 7.6 cm (3.0 in) Base Height 15.2 cm (6.0 in) -
Page 14: Maintenance
Maintenance MODEL 3303 ROD ANTENNA MAINTENANCE To ensure reliable and repeatable long-term performance, annual recalibration of your antennas by ETS-Lindgren’s experienced technicians is recommended. Our staff can recalibrate almost any type or brand of antenna. Please call to receive a service order number prior to sending an antenna to us for calibration. -
Page 15: Warranty
MODEL 3303 ROD ANTENNA Warranty WARRANTY EMC Test Systems, L.P., hereinafter referred to as the Seller, warrants that standard EMCO products are free from defect in materials and workmanship for a period of two (2) years from date of shipment. Standard EMCO Products include the following: v Antennas, Loops, Horns v GTEM cells, TEM cells, Helmholtz Coils v LISNs, PLISNs, Rejection cavities &...
Need help?
Do you have a question about the ETS-Lindgren 3303 and is the answer not in the manual?
Questions and answers