Engine Troubleshooting - RCGF RCGF35CCRE Operator's Manual

3. Switch the ignition to ON, close the choke plate on the carburetor and open the throttle
slightly from the idle position.
4. Use your electric starter to turn the engine over for several seconds, until a popping
sound is heard. This indicates that the engine is firing.
5. Move the choke lever to the open position.
6. Set the throttle to high idle and use your electric starter to turn over the engine until it
starts.
7. After starting, let the engine idle for 30 to 45 seconds. Open and close the throttle
slowly until the engine runs smoothly at idle and at full throttle. Acceleration should also
be smooth. If acceleration is not smooth, adjustments to the carburetor may be
necessary (see Adjustment of the Engine).
8. If your engine does not start, repeat steps 2-7.

Engine Troubleshooting

If your engine fails to start after the preceding starting procedures
please check the following.
Symptom
Engine does not fire
Engine starts,then rpm
Increases till engine cuts
out
This can be done by removing the spark plug from the cylinder and attaching the plug on
the outside of the crankcase. Have an assistant turn the engine over while checking this
and be sure to have the spark plug firmly plugged into the ignition wire.
Warning: The high voltage from the ignition can cause bodily harm, especially when
checking for spark in this manner.
Diagnosis
Ignition battery
voltage low
Battery wires faulty
or loose
Faulty spark plug
or not firing
Engine flooded
Fuel not reaching
engine
Fix
Charge or
replace battery
Replace wires or
Re-connect/check
connections
Replace spark plug
or check for spark
Remove plug,
disconnect fuel
line, rotate prop
to remove fuel
Check for:
a) fuel in tank
b) fuel tubing
cut, blocked,
or kinked
c) carburetor
clogged