Sunsky T5 Manual

bluetooth transceiver T5 Manual
I. Schematic illustration
II. Product features
1. bluetooth V5.0
2. The transmit mode supports two bluetooth devices to
connect and play at the same time
3. Support bluetooth receiver/ transmitter
4. LCD Display
5. Automatically connect the paired bluetooth device after
power on
6. Five minutes no device connection, automatic shutdown
7. Play time:about nine hours after full charge
8. bluetooth support A2DP,AVRCP,HFP,HSP
9. (Only supports audio bluetooth) Support bluetooth DSP
technology of stereo music
10. Aux input / output
11. Private answer
III. Operating instructions
1. Receiver mode RX, blue light
2. Connect bluetooth (RX mode)
Pairing for the first time
2.1 Long press " " 4 seconds to power on.
2.2 Mobile phone search bluetooth pairing name " T5 " and
connect, after the pairing is successful, the display shows
the name of the paired device
2.3 Automatic connection when use again
2.4 Connect two mobile phones.
The second phone search bluetooth name " T5 " and click to
pair, after paired successful, the display also shows the
name of the paired device
3. bluetooth hands-free Use
3.1 Answering the call
In connected state, to answer the incoming call, press
" " to answer, Press again "
3.2 Rejecting the call
When a call comes in but you don't want to answer it, long
press " " key two seconds to reject call.
3.3 Private answer
If you want to use your own phone during the call, long
press the " " button for 2 seconds to switch between
the phone and bluetooth
4. Music control
4.1 Pause/play: click "
4.2 Next song: click "
4..3 Last song: click "
4.4 Volume adjust: long press "
Long press "
increased to the maximum, there will be a " Boom, Boom "
beep
5. Transmit mode TX, green light
6. Connect bluetooth (TX receive mode)
6.1 Turn on and turn the switch to the " TX " , the green light
is on
6.2 The machine will automatically search for nearby
bluetooth devices and show on the display (such as "air
pods"、" i9s", etc.), at this time, the bluetooth device should
be in the pairing state (especially TWS headphones must be
in the pairing state.) If the bluetooth device is not in Paired
" to hang up.
status, it will not be searched by T5. Use "
" " to select the device to be connected and click the
" " button to pair.
Whether the pairing is successful or not, the system will
return to the main interface. After successful pairing, the
main interface will display the name of the bluetooth device.
6.3 Connect the second device
If you need to connect with the second device, double-click
the "
steps in 6.2
6.4 If you do not find the paired name in the bluetooth device
" button
" button
" button
" volume up
" volume down. when the volume is
" or
" button to search, and repeat the connection