Advertisement
Quick Links
Assembly Instructions For TT-Scale
Ford F6 Cube Truck
www.eaelec.com
Made in Canada
This is a scale model kit of the 1951 F6
series medium duty truck. It is equipped with the
"flathead" V-8 engine and a cube bed for
appliance delivery.
3D printed parts Included in the kit:
A. chassis.
B. cab
C. cube bed
Also included:
D. waterslide decal sheet.
Required to complete the kit:
Paint - see painting guide on pages 2 & 3.
Glue - Slow setting CA is best.
Tools -
1. X-acto knife with a sharp #11 blade.
2. #400 and #600 sandpaper.
3. Scissors
WARNING: CHOKING HAZARD
Keep out of reach of small
Note that these ARE NOT TOYS,
AND ARE NOT INTENDED FOR
USE BY CHILDREN UNDER
AGE OF 14. These products are
model railroad equipment and
accessories intended for use by
adults.
B
Page 1
children!
Parts In The Kit
A
C
A
PEX
APPLIANCES
43 Main St. Whitehall, NY
Phone 5-3348
A
PEX
APPLIANCES
43 Main St. Whitehall, NY
Phone 5-3348
D
Advertisement
Related Manuals for Eaelec TT-Scale Ford F6 Cube Truck
Summary of Contents for Eaelec TT-Scale Ford F6 Cube Truck
- Page 1 AGE OF 14. These products are model railroad equipment and accessories intended for use by adults. www.eaelec.com Made in Canada This is a scale model kit of the 1951 F6 series medium duty truck. It is equipped with the “flathead” V-8 engine and a cube bed for Parts In The Kit appliance delivery.
- Page 2 Painting guide - Chassis Paint the chassis is flat black except for the front bumper and wheel hubs which are gloss black. The seat on these trucks was covered with reddish brown leather. Flat Black Red-brown Gloss Black Gloss Black Page 2 www.eaelec.com...
- Page 3 Then the decals are applied. After the decals are dry, I spray with gloss coat to preserve them. Gloss Red Green Silver Silver White Gloss Red Gloss Red Gloss Yellow Silver Green Decal Silver Page 3 www.eaelec.com...
- Page 4 After painting and decals are completed, assemble the truck as shown below using CA glue. Step 1 - attach the cab to chassis Cab in place Appliance Delivery Truck Assembly Completed Step 3 - attach the cube bed to the chassis Page 4 www.eaelec.com...