Advertisement
Quick Links
Advertisement
Summary of Contents for eta ETA-S20RT
- Page 1 ETA-S20RT AC Distribution & Suppressor Unit ETA-S20RT AC Power Distribution & AC Suppressor Unit with Remote Activation 1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A. Telephone: 800-321-6699 • Fax: 800-996-3821 – 1 – ETAsys.com Specifications are subject to change without notice.
-
Page 2: Table Of Contents
ETA-S20RT AC Distribution & Suppressor Unit TABLE OF CONTENTS Important Safety Instructions ........................3 Introduction ............................5 Key Features and Applications ....................... 6 Front Panel Features ..........................7 Rear Panel Features ..........................8 Installation .............................. 9 Specifications ............................10 Warranty ..............................12 1601 Jack McKay Blvd. -
Page 3: Important Safety Instructions
ETA-S20RT AC Distribution & Suppressor Unit IMPORTANT SAFETY INSTRUCTIONS The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. - Page 4 WARNING – WHEN THE DEVICE IS IN USE • To prevent electric shock, do not remove the product cover as there are high voltage components inside. Refer all servicing to ETA Systems. • Should any of the following irregularities occur during use, immediately switch off the power, disconnect the power cord from the AC outlet and contact ETA Systems. Do not to attempt to continue operation with the product as this may cause fire or electric shock: • Smoke or strange smell coming from the unit. •...
-
Page 5: Introduction
6kV or amperage peaks of 3000A. These spikes are very fast and usually only last for a very short period of time. The ETA-S20RT’s circuitry is very fast and can suppress unwanted energy within a nanosecond response and sustain the suppression up to 2 milliseconds, thus ensuring virtually trouble-free protection. -
Page 6: Key Features And Applications
AC distribution. The ETA-S20RT can also be used for power conditioning to eliminate or reduce fuzzy video or frequency audio static pops. The following are just a few examples of applications where the ETA-S20RT can be used: • Restaurants... -
Page 7: Front Panel Features
The 20A rated breaker will open if the combined draw of all AC outlets exceeds 20A. Note: The breaker is designed to exceed its rating for a short period of time. If the breaker is tripped, you must first remove the load from the ETA-S20RT and then push to reset. -
Page 8: Rear Panel Features
4. Light Socket Power Switch Two-position switch to power On/Off the XLR light socket. 5. Remote Activation There are two methods to remotely activate the ETA-S20RT: A. External Switch - The Ext SW terminals are connected to a latching type dry contact closure to activate the ETA-S20RT. Note: The Remote Bypass switch must be shorted for Remote Activation. This feature can be used for Emergency Power Down (EPD), when tied into a normally closed latching contact closure (e.g. -
Page 9: Installation
AC Distribution & Suppressor Unit INSTALLATION Before installing, it is recommended to read the entire manual to ensure proper operation and that all features are being utilized. The ETA-S20RT can be placed on a shelf or rack mounted in a standard 19" width rack. When rack mounted, placement within the rack is flexible however the ETA-S20RT should be within 6' of a dedicated 20A AC outlet. When rack mounting, use Rack Rail type screws of ⁄ " x 1". Always make sure the 20A outlet is properly inspected by a certified electrician prior to connecting the ETA-S20RT. Make sure to inspect the equipment that will be connected to the ETA-S20RT to ensure it does not exceed 20A total amperage draw. -
Page 10: Specifications
ETA-S20RT AC Distribution & Suppressor Unit SPECIFICATIONS Type P ower Conditioner & Suppressor Load Rating Safety Listings ETL (UL 60065 Standard) Front Panel Outlets 1 Unswitched USB Port 1 USB Charge/Light Port (5VDC, 1A) Activation Switch Rocker Circuit Breaker 2 0A Resettable Indicators AC Power On, AC Fault, EVS Protect... - Page 11 ETA-S20RT AC Distribution & Suppressor Unit NOTES: 1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A. Telephone: 800-321-6699 • Fax: 800-996-3821 – 11 – ETAsys.com Specifications are subject to change without notice.
-
Page 12: Warranty
This warranty shall extend from the date of purchase for a period of one year. Additionally, fuses and lamps carry no warranty. ETA Systems will solely at its discretion, replace at no charge or repair free of charge defective parts or products when the product has been applied and used in accordance with our published operation and installation instructions.