Summary of Contents for FMC Technologies Syntron DL-1-A
- Page 1 Syntron® DL-1-A Dental Vibrator ■ Installation ■ Operation ■ Maintenance ©2002 FMC Technologies, Inc. All rights reserved SM1115- 071703...
-
Page 2: Table Of Contents
Thank you for buying your equipment from FMC. This manual will help you to understand how your equipment operates and what is required to maintain peak performance. Please read it thoroughly and keep it on file for reference. Your satisfaction is important to us, so pease direct any comments to our Marketing Communications Department. -
Page 3: Introduction
need replaced, INSPECTION AND LONG TERM STORAGE Upon receipt, carefully unpack and inspect the DL-1-A Dental Vibrator for any damage that may have occurred during shipment. If damage is found, notify the shipping carrier and FMC immediately. If the DL-1-A Dental Vibrator is to be stored for an extended period of time, store the unit indoors in its original shipping carton. -
Page 4: Air Gap
If an apparent problem exists, do not operate the dental vibrator. If parts are found to be defective, they must be replaced immediately. AIR GAP The air gap is the space between the pole faces of the armature and the core. Low current draw indicates that the air gap is too narrow, resulting in a striking condition. -
Page 5: Operating Specifications
Unit in contact with rigid object Isolate unit Or adjacent surface Defective rubber feet *Replace Defective springs *Replace Defective rectifier *Replace Excessive noise Armature and magnet Adjust air gap Assemblies making contact * Replace only with parts supplied or recommended by FMC Technologies. -
Page 6: Parts List
DL-1-A DENTAL VIBRATOR PARTS LIST ITEM DESCRIPTION PART NO Rubber Deck B-102616 Top Cover A-91806 Cap Screw, Fl. Hd. Stl. (1/4”-20 x 5/8”) H0402800 Cover Support A-91814 Spring Clamp A-91816 Spring B-224564-002 Spacer A-97983-2 Spacer A-91817 Coil Clamp A-91810 Cap Screw, Hex Hd. (5/16”-18 x 1/2”) H0306401 Coil Washer A-81849... - Page 7 * Do not remove or paint over safety labels. If safety labels need replaced, contact FMC Corporation for an additional supply, free of charge.
-
Page 8: Wiring Diagram
DL-1-A DENTAL VIBRATOR WIRING DIAGRAM FMC Technologies, Inc. reserves the right to alter at any time, without notice and without liability or other obligations on its part, materials, equipment specifications and models. FMC Technologies, Inc. also reserves the right to...