HP 22er Product End-Of-Life Disassembly Instructions page 4

Step 2: Strip the screws from rear cover, then move rear cover follow the below way ,at last
remove deco
Remove the screws with
Screwdriver
Step 3: To remove the shielding(contain the other material );
(3.1) Dismantle the rear cover supporter
(3.2) Pull out the LVDS/ LED FFCs to separate the base assembly from the unit;
(3.3) Remove the four screws to separate shielding from CB
HP Restricted
24-07-201
Dismantle the rear cover first
from the two marked position
Remove the 8pin FFC from main
board then remove rear cover
Page 2