Page 1
ZP19011 ASSEMBLY INSTRUCTIONS ZIPPITY ASSEMBLY INSTRUCTIONS GALVANIZED STEEL AND VINYL SURFACE ZP19011 MOUNT 2-PACK (30” H X 3 1/4” W) 60 MIN Approximate assembly time Want to see a video on how to assemble this product? Scan the QR code WWW.ZIPPITY-OUTDOOR.COM...
Page 2
ZP19011 ASSEMBLY INSTRUCTIONS GENERAL IMPORTANT INFORMATION Check the inside of the larger pieces in your box for other materials packed inside. When assembling components, place on a non-abrasive surface (i.e. shipping box) to avoid scratching. We recommend an area approximately 5’x 8’ for unobstructed assembling.
Page 3
ZP19011 ASSEMBLY INSTRUCTIONS 3 1/4 in 30 1/4 in 3 1/2 in Ø3/8 in 4 in WWW.ZIPPITY-OUTDOOR.COM...
Page 4
ZP19011 ASSEMBLY INSTRUCTIONS LAY OUT MATERIALS STEP 1: Surface Mount (2) NOT INCLUDED WITH PURCHASE: ¼” Hex Bolts(8) ¼” Washer (8) ¼” x 4” Hex Head ¼” x 3” Concrete Bolt w/ Nut and Wedge Anchor (8) 2” x 6” Wood Support (1)
Page 5
ZP19011 ASSEMBLY INSTRUCTIONS MOUNT TO CONCRETE STEP 2A: STEP 2A.1 STEP 2A.2 Locate the position of your Surface Drill (4) ¼” diameter holes 3” deep through Mount and mark the four anchor the concrete. You will need a hammer drill and a masonry drill bit.
Page 6
ZP19011 ASSEMBLY INSTRUCTIONS MOUNT TO WOODEN DECK STEP 2B: STEP 2B.1 STEP 2B.2 Locate the position of your surface mount and Measure the distance between your joists mark the four bolt holes. and fasten a 2” x 6” wood support direct- ly below where the surface mount will be installed.
Page 7
ZP19011 ASSEMBLY INSTRUCTIONS STEP 2B.5 Once level, fasten the surface mount using (4) ¼” x 4” hex head bolts with nuts and washers. WWW.ZIPPITY-OUTDOOR.COM...