TrafSys Walker Wireless THM3020 Manual

W i r e l e s s O v e r
W i r e l e s s O v e r
S e n s o r
S e n s o r
M o d e l : T H M 3 0 2 0
M o d e l : T H M 3 0 2 0

Introduction

The Traf-sys/Walker Wireless Wireless Overhead
Thermal Sensors are a discreet and highly
accurate solution to track foot traffic through a
given area or entrance. The counter consists of
two parts, a base and the sensor, and determines
traffic using heat signatures from customers'
heads; upon a heat signature crossing configured
IN/OUT lines, a count of the appropriate direction
is transmitted to the wireless transmitter.

Table of Contents

Introduction ..................................................................................................................... 1
Table of Contents ............................................................................................................ 1
Required Equipment........................................................................................................ 1
Mounting and Orientation ................................................................................................ 2
Single Sensor Entrance ............................................................................................... 2
Calibrating the Sensors ................................................................................................... 4
Required Equipment for Calibration ............................................................................. 4
Attaching the Setup Module......................................................................................... 4
Single Sensor Entrance Calibration ............................................................................. 6
Multiple Sensor Entrance Calibration ......................................................................... 14
Troubleshooting ............................................................................................................ 16
Thermal Issues .......................................................................................................... 16
Mounting Issues ........................................................................................................ 16
Software Issues ......................................................................................................... 16
Safety and Occupancy Issues ................................................................................... 16
LED Codes ................................................................................................................ 17
Appendix A: Sensor Base Wiring................................................................................... 18

Required Equipment


Traf-sys/Walker Wireless Thermal Sensor Configuration Software

Windows XP or later laptop PC with an available 9 pin RS-232 Serial Port.

THM3020S Setup Module (do not attempt to use any other setup module).

Straight and Philips head screwdrivers (not included)

Mounting bolts/screws (not included)

Wall mount bracket or ceiling mounting plate (optional; not included)

Wireless Transmitter and Power Supply (included in kit)

RJ-45 patch cables (included in kit)

Category 5 Ethernet cable for multiple sensor connection (not included)

Female to female RJ-45 Category 5 Ethernet jacks (two per sensor)

Cable/jack tester
Traf-sys/Walker Wireless, Inc | 190 Industry Drive - Pittsburgh, PA 15275
Ph: 888-815-6568 | Fax: 928-222-7279 |
h e a d T h e r m a l
h e a d T h e r m a l
www.trafsys.com
Page 1 of 18