Table of Contents
Advertisement
Quick Links
Instructions
Pro Xpc™ Auto Controller Main Board
Replacement
For controlling the Graco Pro Xpc Auto Electrostatic Spray Guns. For professional use only.
Models 17H286, 17H661
Not approved for use in explosive atmospheres or hazardous locations.
Important Safety Instructions
For complete warnings and safety instructions see Pro Xpc™ Auto
related manuals. Save these instructions.
PROVEN QUALITY. LEADING TECHNOLOGY.
3A5188A
EN
Advertisement
Table of Contents
Summary of Contents for Graco Pro Xpc
- Page 1 Instructions Pro Xpc™ Auto Controller Main Board 3A5188A Replacement For controlling the Graco Pro Xpc Auto Electrostatic Spray Guns. For professional use only. Models 17H286, 17H661 Not approved for use in explosive atmospheres or hazardous locations. Important Safety Instructions For complete warnings and safety instructions see Pro Xpc™ Auto related manuals.
-
Page 2: Table Of Contents
Maximum Gun Voltage Output Controller Description at Applicator 17H287 24Y307 Pro Xpc Auto, solventborne 100 kV 17H661 24Y308 Pro Xpc Auto, waterborne 60 kV Related Manuals Manual No. Description 332992 Pro Xpc Auto Electrostatic Air Spray Gun 333266 Pro Xpc Auto Controller 3A5188A... -
Page 3: Warnings
Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. -
Page 4: Repair
Repair Repair Prepare System 1. Record the settings on your existing controller. These can be logged by using an SD Card and setting the Log Level to at least 1. To avoid electric shock, turn off equipment power and shut off power at main circuit breaker before Setting Values installing. - Page 5 Repair 3. Using the Phillips head screwdriver, loosen the 5. For easier service, remove the cable connections 4 screws holding the front access cover in place to the power board (PB) and power supply and carefully remove the front access cover. board (PS) (the power supply is in the controller housing).
- Page 6 Repair 7. Remove the replacement board from the 10. Replace connections on the main board. packaging. Orient it properly and place it onto a. Replace the 3 main board green connections the standoffs. (G). Note the keying features and push into 8.
-
Page 7: Notes
Notes Notes 3A5188A... -
Page 8: Graco Standard Warranty
Graco to be defective. This warranty applies only when the equipment is installed, operated and maintained in accordance with Graco’s written recommendations. This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or substitution of non-Graco component parts.