Crown CT35046F Original Instructions Manual page 11

Symbol
IPX8
Appliance designation
Submersible pumps are designed for pumping clean,
rain and chlorinated water� They can be used for drain-
ing reservoirs and ponds, maintaining a set water level
in the reservoir, organizing water intake from the depth
(in pits, wells, reservoirs) and supplying it to a height�
Appliance components
1 Grid
2 Housing
3 Handle
4 Outlet branch pipe
5 Loop
6 Groove
7 Cable of floating on / off switch
8 Floating on / off switch
9 Fitting *
10 Hose *
11 Hose clamp *
12 Quick change adapter *
13 Quick change fitting *
14 Base
15 Base screw
16 Impeller
17 Cap
18 Cap screw
Meaning
Locked�
Unlocked�
Prohibited�
Protection class�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Attention� Important�
Useful information�
Do not dispose of the appli-
ance in a domestic waste
container�
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of appliance
elements
Before any procedures remove the power cable
from the socket.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Mounting / dismounting / setting-up of
some elements is the same for all appli-
ance models, in this case specific mod-
els are not indicated in the illustration.
The water is supplied from the appliance through
a flexible reinforced hose 10 (rubber or plastic, not
included in the delivery set) connected to the out-
let branch pipe 4 through the fitting 9. When con-
necting the appliance to steel or plastic pipes, it is
necessary to use a flexible hose at least 2 meters
long.
Fitting preparation (see fig. 1-3)
Hoses of different diameters as well as quick change
threaded fittings can be connected to the fitting 9 (see
fig. 1-2).
• Using a fine-toothed saw, carefully cut off the unnec-
essary part of the fitting 9 (see fig. 1-2) and connect ei-
ther a hose or a quick change fitting as described below.
• Connect the fitting 9 to the outlet branch pipe 4 as
shown in the figure 3. Disconnect in the reverse order.
Hose connection (see fig. 4)
• Put the hose clamp 11 on the end of the hose 10
(see fig. 4.1).
• Carefully slide the end of the hose 10 onto the fit-
ting 9 (see fig. 4.2).
• Tighten the screw of hose clamp 11 (see fig. 4.3).
Hose connection with a quick change adapter (see
fig. 5)
• Install the quick change adapter 12 on the end of the
hose 10 (see fig. 5.1).
• Screw the quick change fitting 13 onto the fitting 9
(see fig. 5.2).
• When connecting, put the quick change adapter 12
onto the quick change fitting 13 and push until it clicks,
as shown in the fig. 5.3.
• When disconnecting, move the bushing of the quick
change adapter 12 as shown in the fig. 5.4 and re-
move the quick change adapter 12 from the quick
change fitting 13�
Note: do not use a hose having a cross
section under 19 mm (3/4") (for CT35046F)
or 30 mm (1-1/4") (for CT35047), it will in-
crease the load on the appliance and re-
duce its performance.
English
11