Advertisement
Table of Contents
WITH THE EUROMEX AE.5168 TEMPERATURE CONTROLLER
Use:
1) Connect the AE.5168 temperature controller to
the heating stage by means of the connector at
the back side of the controller (Z) and fasten the
connector
2) Connect the plug to the mains supply (W)
3) Set the main switch on the front panel to position 1
All digits of both displays (A) and (B) will light
up as a test
The display (A) will show:
"OFF"
4) Push the on/off
To switch the heating stage on or off.
At first use the upper display shows 37° C as
wanted temperature for the heating stage
INSTRUCTION MANUAL
FOR HEATING STAGES
(Z)
(F) switch
(A)
(B)
(D)
(E)
(W)
(C)
(F)
(G)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Euromex AE.5168
- Page 1 INSTRUCTION MANUAL FOR HEATING STAGES WITH THE EUROMEX AE.5168 TEMPERATURE CONTROLLER Use: 1) Connect the AE.5168 temperature controller to the heating stage by means of the connector at the back side of the controller (Z) and fasten the connector 2) Connect the plug to the mains supply (W)
- Page 2 Note: At a room temperature of about (23°) it will take about 8 minutes to reach a stable temperature of 37° C The display (B) shows the temperature at the sensor. This will keep on varying around the set temperature! The temperature of the heating stage will remain stable, as shown in the above graphic 5) The desired temperature can be set by:...
- Page 3 EP0 or EP1 Defect of the controller. Contact your dealer or Euromex When the display does not function, check wether the main switch is in the position 1. If it is, check the fuse.
- Page 4 EUROMEX Microscopen B.V. HOLLAND www.euromex.com...
Need help?
Do you have a question about the AE.5168 and is the answer not in the manual?
Questions and answers