Displays2go LCKDCHTTBK Assembly Instructions

ASSEMBLY INSTRUCTIONS
TRASH RECEPTACLE - TOP RAIL

PARTS

A Top Panel
B Side Panel
C Bo�om Panel
D Back Panel
F Toe Kick Panel
G Swing Door
g "THANK YOU" Flip Door
H Divider Panel
ATTENTION: Unpack the unit and confirm all hardware are present. If any hardware required is missing, or if you have any
ques�ons regarding our products, please contact D2G customer service.
Assemble the unit on a carpeted floor or on a so� surface work area to avoid any scratch.
A phillips screw driver is needed. 2 people recommended.
1. Insert 2 cam posts (H2) into holes in Panel C. Tighten only un�l
snug. Fit cam holes in the edge of Panel F over the cam posts. Insert
2 cam locks (H1) into cam lock holes on Panel F, use a phillips screw
driver to turn cam locks clockwise to secure cam posts. DO NOT
over-�ghten.
H1
Cam Lock
2. Insert 2 cam posts into holes in Panel D as shown below. A�ach
assembled Panel C to Panel D by inser�ng cam posts into the cam
lock holes. Insert 2 cam locks into cam lock holes on Panel C, turn
cam locks clockwise with a phillips screw driver to secure cam posts.
Ver. 03/18
1pc
H1 Cam Lock
2pcs
H2 Cam Post
1pc
H3 Wood Screw
1pc
1pc
H4 Concealed Hinge
1pc
H5 Tray Rail
1pc
H6 Screw
1pc
3. Insert 9 cam posts into holes in Panel B as shown below. A�ach
the assembled panels in STEP 2 to Panel B and use cam locks to
securely lock it in place.
H2
Cam Post
4. Assemble Panel H by fi�ng cam lock holes in Panel H with 2 cam
posts. Lock Panel H securely by inser�ng cam locks and rota�ng
clockwise.

HARDWARE

30pcs
30pcs
12pcs
2pcs
3pcs
6pcs
1 of 2