Troubleshooting; Specifications; Warranty - MEE AUDIO MATRIX 3 AF68-LL User Manual

Low latency bluetooth wireless hd headphones
Table of Contents

Advertisement

DISABLING AUDIO PROMPTS
Voice prompts and other audible notifications of the Matrix3
can be disabled. To turn off all audio prompts, put the Matrix3 in
standby mode (see the Enabling Multipoint section) and then
press and hold the Volume Down button for 4 seconds, until you
hear two descending tones.
To turn audio prompts back on, repeat the above procedure using
the Volume Up button and listen for two ascending tones.
Note: this will turn off all sound alerts and other audio notifications.
[HOLD 4 sec] Turn Audio Prompts On
[HOLD 4 sec] Turn Audio Prompts Off
SAFETY AND CARE
Clean with a soft cloth, damp with diluted soap water solution
if necessary. Do not use chemical cleaners.
When not in use, power the headphones off and store in the
included protective carrying case.
Battery performance will be severely decreased when
stored in extreme temperatures: below -10°C/14°F or above
45°C/113°F including direct sunlight.
The lifetime of the battery will be significantly reduced if your
headset is not charged for a long time. It is recommended to
charge your headset at least once a month.
There are no user replaceable/reparable parts in the headset.
Disassembling it will void your warranty.
If the device comes in contact with liquids, quickly wipe
away. If submersed in water, do not turn the device on until
completely dried. Note: liquid submersion voids the warranty.
Do not use around flammable gasses as fire or explosion
may occur.
USE AS WIRED HEADPHONE
The Matrix3 can be used as a wired headphone with the
included 3.5mm stereo audio cable. This allows use when the
battery is depleted and with devices that do not have Bluetooth
(such in-flight entertainment systems) or aren't paired.
The wired connection can also be used while the Matrix3 is
connected to another device wirelessly via Bluetooth. Bluetooth
audio takes precedence over wired audio. Wired audio will be
partially muted whenever a signal is transmitted via Bluetooth
and will resume approximately 5 seconds after the Bluetooth
transmission ends.
Note: the built-in microphone of the Matrix3 will not work when the
headphones are used only in wired mode.
WARNING
Using headphones at high volumes for extended periods of time
will result in permanent hearing damage. It is advised you keep
volume levels moderate to low at all times for your safety. Turn
the volume all the way down after connecting your earphones,
then gradually increase the volume until you reach a comfortable
listening level. Do not use while driving a car, cycling, operating
machinery, or performing other activities that require hearing
surrounding sounds.

TROUBLESHOOTING

Visit the Bluetooth Support Page at
www.MEEaudio.com/Bluetooth for troubleshooting procedures.

SPECIFICATIONS

Visit www.MEEaudio.com/Matrix3 for product specifications.

WARRANTY

The Matrix3 is covered by a 1-year manufacturer warranty.
For more information, contact your local MEE audio dealer
or visit www.MEEaudio.com/Support
3.5mm

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MATRIX 3 AF68-LL and is the answer not in the manual?

Questions and answers

Table of Contents