Related Manuals for Safe Fleet RVS-130
Summary of Contents for Safe Fleet RVS-130
- Page 1 Instruction Manual Advanced Blind Spot Sensor System RVS-130 VEHICLE SAFETY - IT'S ALL WE DO.
-
Page 2: Table Of Contents
Item List........02 Technical Specification......03 Wiring Diagram. -
Page 3: Technical Specification
Technical Specification Operating frequency 24.0 ----24.25GHZ Transmit power 15dbm Detection range 40 degree (Horizontal ) Detection ability 5 targets can be detected at the same time Speed range 0.35mph---137mph Speed accuracy < 0.35mph Direction of movement Approached or overtaken by vehicles Speed Restriction 1.The GPS Antenna when connected activates noti cations over 20mph (Example LED + Speaker) -
Page 4: Wire Connection Diagram
L-SENSOR Buzzer R-SENSOR M ain Unit L-SENSOR Buzzer M ain Unit R-SENSOR Wire Connection Diagram Rear View Safety... -
Page 5: Installation Guide
Using the voltage Multi-meter, locate the left and right turn signal trigger wires behind the front turn signals. Once verified, connect the left and right signal wires of the RVS-130 wire harness to the correct signal wires. Reverse With Confidence ™... - Page 6 Step 3. LED Indicator Installation Place the LED indicators where it is visible for the driver. Ideally on the A-pillar. L - Left LED R - Right LED Step 4. Buzzer Location Ensure speaker is installed in accessible area to allow driver access to volume controls.
-
Page 7: Alert Conditions
NOTE! Illumination of the LED indicator on the control box: 1.The LED comes on solid when the system is first powered up; 2.The LED blinks slowly while the GPS module is connected to the satellite; 3.The LED blinks quickly while sensing moving objects approaching in the blind spot (same frequency as to the alarm LED indicators &... -
Page 8: Alert Characteristics
Alert Characteristics A. Blind detection on right side: 1. R-LED indicator will be activated when there is an object approaching to the right side blind area of your vehicle (see Fig.16). 2. If the right turn signal of your vehicle is triggered at the same time, the R-LED indicator will be blinking and the buzzer will be beeping as well (with the same frequency). -
Page 9: Troubleshooting
Troubleshooting Issue Reason Solution LED light does not Incorrect connection or pins not Check the harness and make sure work making contact connection is correct LED light is broken Replace LED light Opposite LED Microwave sensor or LED Make sure RED is driver side and indicator indicators are plugged in to the YELLOW is passenger side. -
Page 10: Customer Service Bulletin
Customer Service Bulletin CSB00101 Affected Products: RVS-128, RVS-129, RVS-130. Summary This bulletin addresses three solutions to the issue of false alarms with the RVS-128, RVS-129, RVS-130: • Sensor's orientation. • Large surface anomalies in the sensor field of view. • Use of steel screws in conjunction with the environment, resulting in reflections to the sensors. - Page 11 Surface anomalies in sensor field of view Large objects attached to the side of the vehicle or other large surface anomalies, such as the wheel well near the sensor, may cause reflections to the sensor resulting in false alarms. The wheel well it may have reflections from the shape of the wheel well or also the rotation of the wheel will look like objects traveling toward the sensor.
-
Page 12: Safety Information
If you have questions about this product, contact: Rear View Safety 1797 Atlantic Avenue Brooklyn, NY 11233 Tel: 1.800.764.1028 IN NO EVENT SHALL SELLER OR MANUFACTURER BE LIABLE FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES OF ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT. -
Page 13: Warranty
ONE YEAR WARRANTY REAR VIEW SAFETY, INC. WARRANTS THIS PRODUCT AGAINST MATERIAL DEFECTS FOR A PERIOD OF ONE YEAR FROM DATE OF PURCHASE. WE RESERVE THE RIGHT TO REPAIR OR REPLACE ANY SUCH DEFECTIVE UNIT AT OUR SOLE DISCRETION. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR A DEFECT IN THE SYSTEM AS A RESULT OF MISUSE, IMPROPER INSTALLATION, DAMAGE OR MISHANDLING OF THE ELECTRONIC COMPONENTS. -
Page 14: Disclaimer
DISCLAIMER REAR VIEW SAFETY AND/OR ITS AFFILIATES DOES NOT GUARANTEE OR PROMISE THAT THE USER OF OUR SYSTEMS WILL NOT BE IN/PART OF AN ACCIDENT OR OTHERWISE NOT COLLIDE WITH AN OBJECT AND/OR PERSON. OUR SYSTEMS ARE NOT A SUBSTITUTE FOR CAREFUL AND CAUTIOUS DRIVING OR FOR THE CONSISTENT ADHERENCE TO ALL APPLICABLE TRAFFIC LAWS AND MOTOR VEHICLE SAFETY REGULATIONS. -
Page 15: The Rvs Difference
THE RVS DIFFERENCE COMPETITION THE RVS DIFFERENCE Sensors mounted Our sensors mounted in the in rear corners front of the vehicle 82FT RANGE! Reverse With Confidence ™... - Page 16 If you have any questions about this product, contact: Rear View Safety, Inc. 1797 Atlantic Avenue Brooklyn, NY 11233 800.764.1028 Better Cameras. Better Service. IT’S OUR GUARANTEE.