Team Young EZCon RX15x3-3SE-1 User Manual & Warranty

Power Strip/RX15x3-3SE-1
User Guide/Warranty
Package contains

 

Precautions for safe use

● The product complies with NCC Administrative Regula-
tions on Low Power Radio Waves Radiated Devices：
Article 12：Without permission granted by the NCC,
any company, enterprise, or user is not allowed to
change frequency, enhance transmitting power or alter
original characteristic as well as performance to an
approved low power radio-frequency devices.
Article 14：The low power radio-frequency devices
shall not influence aircraft security and interfere legal
communications; If found, the user shall cease operating
immediately until no interference is achieved.
The said legal communications means radio communi-
cations is operated in compliance with the Telecommu-
nications Act. The low power radio-frequency devices
must be susceptible with the interference from legal
communications or ISM radio wave radiated devices.
● Indication of safety marks: If recommended precautions
and safe operating methods are not followed, physical
injury and damage of electrical appliances may be
caused.
v��
● This product is for indoor use but not suitable for
outdoor use.
● Please use this product in dry condition instead of
exposing it in beads of water or in high humidity.
● Do not place this product near any equipment that
generates heat, such as heaters, electric heaters, gas
burners, or other heat-generating equipment.
● Do not disassemble the Power strip yourself.
● Do not use foreign objects to insert the Micro-B receiving
port of the Power strip.
●Please place and fix the Power strip properly to avoid
damage by collision and dropping from high place.
●Only one Power strip can be used for one circuit of
the Wall Outlet Socket. The current loading must not
over 15A or with power loaded greater than 1,650W.
 Power Strip
Connected or extended with other power strips for
 Star wrench
extension is not allowed.
 Quick Instruction Manual
●If the Power strip is damaged, deformed, or the insulation
of power cord appears breakage, the Power strip should
be replaced.
●Do not use chemical/corrosive/solvent or bleach to clean
the Power strip as this may damage the housing of it.
Please wipe it with a dry and clean cloth.
 Outlet #1
 LED indicator light #1
 Outlet #2
 LEC indicator light #2
 Outlet #3

Components of Power Strip

 LED indicator light #3
 Handle
 Reset button
 Micro-B receiving port

Instructions of usage

1 Use PCtools to add the layout of " Power strip" with 1 Use PCtools to add the layout of " Power strip" with
preferred nomination, for example: Outlet#1(Fan), preferred nomination, for example: Outlet#1(Fan),
Outlet#2(TV), and Outlet#3(Set-Top Box), then using Outlet#2(TV), and Outlet#3(Set-Top Box), then using
USB cable to connect PCtools and Smart remote USB cable to connect PCtools and Smart remote
controller. Then long press the "SET" button of the
controller. Then long press the "SET" button of the
Smart remote controller to enter into the setting option. Smart remote controller to enter into the setting option.
After selecting "Data transmitting/importing", please After selecting "Data transmitting/importing", please
press "ON" button (or use Hotkey: SET + Up direction press "ON" button (or use Hotkey: SET + Up direction
button) as shown below to write the layout to the Smart button) as shown below to write the layout to the Smart
remote controller: remote controller:
PC-Tx Mode PC-Tx Mode
Tx-Rx Mode Import OK
Tx-Tx TxSide
Tx-Tx RxSide
2 Confirm that the Power strip is not connected to supply
mains, and its LED indicator light should not be on
at this stage. First remove the screws on both sides
to disassemble the handle by using the hexalobular
socket screwdriver enclosed in the package, and the
Micro-B receiving port of Power strip could be found
as shown below: