7th Sense medialon Showmaster G Hardware User's Manual

Specification
Environmental Characteristics
Temperature
Humidity (non-condensing)
Altitude
Product Electrical Rating
19 VDC ⎓ 4.7 A (Max)
Showmaster Go
Showmaster Go 100-240 VAC ~ 3-1.5 A,
Power Supply Unit 60-50 Hz
End of Service Life
Dispose of the equipment and any components in accordance with all local and national
safety and environmental requirements.
Regulatory Compliance Statements
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with this user guide, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
European Union
This is a Class A product. In a domestic environment, this product may cause radio interference, in
which case the user may be required to take adequate measures.
7thSense Design Ltd : 2 The Courtyard, Shoreham Road, Upper Beeding, BN44 3TN, UK
www.7thsense.one
Copyright © 7thSense Design Ltd : M557-2
Operating Non-operating
+15 to +30 ° C -10 to +50 °C
10 to 90% 5 to 95%
<2000 m <10000 m
Weight (kg)
Dimensions (H × W × D)
1.4 44 mm × 145 mm × 152 mm
— 13 mm × 126 mm × 49 mm
September 2021
Showmaster G
Hardware User Guide
Customer Support: https://portal.7thsense.one
Support
If your Medialon Showmaster Go was purchased through one of our regional distributors, please
contact your supplier directly for support.
Visit our customer support portal where you can find a wide range of support documentation,
together with contact information.
Warranty
Standard warranty is 24 months, return-to-supplier. Please contact your supplier if you require an
extended warranty.
Please ask for instructions and request authorisation before returning a unit to your supplier.
Operating Instructions
Operating instructions for your Showmaster Go can be found in the Medialon section of the
7thSense customer support portal.
Handling and Installation
Unpacking
Unpack your Showmaster Go carefully onto a clean surface and examine it for any signs of transit
damage. Contact your supplier immediately if anything appears to be damaged, or any parts
missing. Please retain all packaging in case of future need to return a Showmaster Go unit.
Rack mounting
A rack mounting frame and blanking plates can be supplied for mounting up to 3 Showmaster Go
units as a 1U height rack unit.
Full details for safely mounting Showmaster Go are given in document M555: 'Mounting the
Medialon Showmaster Go' available from the 7thSense customer support portal.
Dual NIC ports
On the rear right-hand side, the RJ45 port labelled 'NIC 1' is factory-set to
a static IP and 'NIC 2' to DHCP. A label with this initial static IP address is
provided on each unit.