1. Manuals
  2. Brands
  3. Carlson Manuals
  4. Jacks
  5. Handy 22100
  6. Instructions

Carlson Handy 22100 Instructions

Moto-roll jack
Hide thumbs
1
2
3
4

Advertisement

Table of Contents

ITEM 22100
Handy, Division of Janco Industries, Inc. warrants to the original purchaser of this product, all parts to be free from defects
in manufacture for a period of one (1) year from date of delivery. Notice of a defective part must be received in writing at
Handy Division of Janco Industries, Inc. within one (1) year of purchase. All defective parts must be returned to Handy
Industries and which, upon our examination any parts which are defective in manufacture or workmanship, will be
replaced or put in good operating condition. This warranty does not apply to damage resulting from accident, improper
installation, repair, operation or maintenance, negligence or neglect. THE COST OF SUCH REPLACEMENT OR REPAIR
SHALL BE EXCLUSIVE REMEDY FOR ANY BREACH OF ANY WARRANTY AND HANDY INDUSTRIES SHALL NOT
BE LIABLE TO ANY PERSON FOR CONSEQUENTIAL DAMAGE, OR INJURY, OR COMMERCIAL LOSS RESULTING
FROM ANY BREACH OF WARRANTY. HANDY INDUSTRIES MAKES NO WARRANTY OR MERCHANTABILITY,
MAKES NO WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND MAKES NO OTHER WARRANTY
EXPRESSED OR IMPLIED, INCLUDING IMPLIED WARRANTY ARISING FROM THE COURSE OR DEALING OR
USAGE OF THE TRADE.
MOTO-ROLL JACK
INSTRUCTIONS – PARTS DRAWING

HANDY LIMITED WARRANTY

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Handy 22100 and is the answer not in the manual?

Questions and answers

Summary of Contents for Carlson Handy 22100

  • Page 1 MOTO-ROLL JACK INSTRUCTIONS – PARTS DRAWING ITEM 22100 HANDY LIMITED WARRANTY Handy, Division of Janco Industries, Inc. warrants to the original purchaser of this product, all parts to be free from defects in manufacture for a period of one (1) year from date of delivery. Notice of a defective part must be received in writing at Handy Division of Janco Industries, Inc.
  • Page 2 1. Remove all contents from packaging (FIG 1). 2- Fasten bottle jack to jack plate as shown (FIG 2). Use provided 5/16 bolts, lock washers, and nuts. The release valve on the jack should point towards the caster mounts end of the frame.
  • Page 3 3- Once the jack is fastened to frame, install the pedal assembly onto the jack, using the provided pins and keeper clips. After pins are in place, install spring onto rod first, then extend to hole in jack plate. (FIG 3) (NOTE: You may have to spread open each end of the spring with a needle nose pliers).
  • Page 4 6- Set entire jack assembly onto blocks to install the fixed wheel with the provided 3/8 bolt, washer, and nuts. Followed by the swivel caster and the provided 1/2" flanged nut. See figure x. (FIG 6) Operating Instructions: 1. With the jack in the lowered position slide it under the motor cycle, on the opposite side of the bike from the kick stand.

Table of Contents