ATTO Technology FastStream SC 7700 Quick Start Manual page 2

If a DHCP server is available on your network, an
address is assigned automatically by the server. Note
the assigned address:
_____________________________________
If you do not have a DHCP server, get an IP address and
subnet mask from your network administrator, type it
into the area provided, and select Next.
5 Click on Launch Browser.
Your browser points to the ATTO ExpressNAV splash
screen. If you use Internet Explorer as a browser,
continue on to Set up Internet Explorer
continue on to Begin initial
Set up Internet Explorer
1 Open your browser.
2 Select Internet Options.
3 In the Internet Options screen, select the Security
tab.
4 Click on the Trusted Sites icon.
5 Click on the Sites button.
Exhibit 1 One view of how to connect the FastStream into a rack: brackets may be mounted on either the front or the connector sides
of the FastStream.
FastS tream
enclosure
a. A ttach brackets to both sides of the F astS tream
enclosure using brackets and screw s supplied by
A TTO .
Exhibit 2 Detail of the connector side of the FastStream enclosure.
below. If not,
configuration.
6 In the text box Add this Web site to the zone, add the
IP address of the appliance. You may use wild cards.
7 Click on Add.
8 Uncheck the Require server verification check box.
9 Click OK.
10 At the bottom of the Internet Options box, click on OK
and close the box.
Begin initial configuration
1 The ExpressNAV interface welcome screen appears.
Click on Enter Here.
2 Type in the user name and password.
Note
The default user name is root; it is case insensitive.
The default password is Password; it is case
sensitive. It is best practice to change the passwords.
3 Initialize drives and set up RAID groups using the
wizards provided in ExpressNAV. Refer to the
Installation and Operation Manual for details.
FastS tream
b. A ttach the enclosure /bracket assem bly to the
rack using the screw s needed for your rack .
enclosure