Schrack HHDC2002 Quick Start Manual

HHDC2002 / HHCP2002 Connectivity for Omnimedia cables Quick Start Guide
HHDC2002
HHCP2002....
Required tools: Screw driver, Cutter, Flush cutter.
Cut the rip-cord and make a small incision in the outer
jacket (perpendicular to the cable).
Tear-off the outer shield, locate the drain wire and
wind the drain wire around the outer shield.
Place the back cover over the cable. The rest of the
procedure is similar for both types of connectors.
Verify that the organizer sits on the bottom of the back
cover. Correct by pulling the wires.
070712_HHDC2002_QSG_EN.doc
Make a small (+/- 3 cm) incision at the end of the cable
and peel open the cable jacket.
Tear-off the outer jacket.
Make a small incision in the shielding of the brown
pair and tear off the foil.
Orange
Green
Preposition the pairs for easy insertion in the wire
organizer.
Firmly pull the wires in the wire organizer, starting with
the brown pair then the blue pair.
Page 1
Locate the rip-cord and tear the cable open over a
length of +/- 10 cm.
HHDC2002 -> 2,5 cm
HHCP2002 -> 1cm
Make a small incision in the outer shielding foil.
Remove and cut the foam foils around the other pairs.
Brown
Blue
Slide the wire organizer over the pairs and push it in
the back cover.
The wire organizer must be held down in the back
cover at all times!
Schrack