Kallista Per Se P77618-00-CP Installation Manual

Record your model number below
for future reference:
Mark the floor where shown, and
3
drill two 5/16" (8 mm) holes 1/2"
(13 mm) deep.
Ø 5/16"
(8 mm)
16-5/8"
12-1/8"
(422 mm)
(308 mm)
8 On the top of the table, position
a punch in the center of the
marked hole. Gently tap the
punch with a hammer.
Install the faucet.
13
1295309-2-D
CAUTION: Risk of personal
injury.
Product can break, chip, and cause
injury if handled carelessly. Get help
lifting the lavatory.
Measure and mark the hole
4
locations on the wall on both
sides of the centerline.
1-3/16"
(30 mm)
9"
(229 mm)
32-1/8"
(816 mm)
27-1/4"
(692 mm)
12-1/8"
(308 mm)
9 Use the punch and a file to
enlarge the hole as needed.
Install a threaded adjustment pad
14
into each leg support.
Instructions are for installation to
wood frame construction. For other
installations, use bracing and
fasteners of sufficient size and
strength.
Secure the leg frame brackets to
5
the wall with appropriate
fasteners. The setscrew notch
should face the floor.
10 Generously apply 100% silicone
sealant around the rim of the
sink.
Assemble the bracket,
15
escutcheon, nut, and bolt. The
bolt should stick up no more than
1/2" (13 mm) higher than the
escutcheon.
1/2"
(13 mm)
Max
Silicone
Adhesive
1 Install 2x6 backing behind the
finished wall.
32-5/8"
(829 mm)
Drill 3/16" pilot holes. Level and
6
secure the mounting brackets
with appropriate fasteners.
11 Place the table upside down.
Position the sink over the hole.
Assemble and press together the
16
leg frame assemblies. Secure
with the setscrews.
3/16" 5/16"
100%
Silicone
Plus:
Sealant
• Fasteners
2 Mark the centerline on the floor
and wall.
Using a compass, locate and
7
draw an outline of the faucet
holes on the top of the table.
8"
(203 mm)
4"
2"
(102 mm)
(51 mm)
8"
(203 mm)
12 Rotate the clips over the rim.
Tighten the fasteners and trim
excess fastener length. Wipe
away excess 100% silicone
sealant.
Insert the threaded adjustment
17
pads into the floor holes.
Assemble the leg frame
assemblies to the leg frame
brackets. Tighten the setscrews.