Advertisement
Question: How do you check the transmission oil level in
300 Series Hole Diggers?
Answer: Follow procedure in the Operator Manual.
Note: This information applies only to the General 330H, 343H and 357H Hole Diggers.
300 Series Hole Diggers are shipped from the factory without oil in the
transmission. Oil is provided in the original shipping carton. Failure to
properly fill and operate the transmission with oil can result in damage that
is not covered by the product warranty program.
Need help?
Call us at 800.533.0524, or
email: support@generalequip.com
Steps below to check oil level.
1. Do not check oil level with the engine running!
2. Place the Hole Digger on a level surface.
3. Wipe any dust or dirt from the transmission oil filler/level
plug area.
The oil filler/level plug is located on the side of the
transmission. FIGURE 1.
4. Remove the plug with a suitable wrench.
FIGURE 2.
HOLE DIGGING: MAINTENANCE
CAUTION!
April 2013 • ISSUE 16P
FIGURE 1.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for General 300 Series
- Page 1 Question: How do you check the transmission oil level in 300 Series Hole Diggers? Answer: Follow procedure in the Operator Manual. Note: This information applies only to the General 330H, 343H and 357H Hole Diggers. CAUTION! 300 Series Hole Diggers are shipped from the factory without oil in the transmission.
- Page 2 HOLE DIGGING: MAINTENANCE April 2013 • ISSUE 16P 5. The transmission oil level is to be maintained at the bottom of the oil filler/level plug hole. FIGURE 3. 6. If the oil level is not visable, add oil up to bottom of the hole. DO NOT OVERFILL.
Need help?
Do you have a question about the 300 Series and is the answer not in the manual?
Questions and answers